lpfc 8.3.42: Fixed not able to log informational messages at early stage of driver init time
Subsystems (2)
PATCH 2/18 lpfc 8.3.42: Fixed not able to log informational messages at early stage of driver init time
Fixed not able to log informational messages at early stage of driver init time
Signed-off-by James Smart <[email protected]>
---
lpfc_init.c | 12 +++--------- 1 file changed, 3 insertions(+), 9 deletions(-)
drivers/scsi/lpfc/lpfc_init.c +3 -9
@@ -4859,6 +4859,9 @@ lpfc_sli4_driver_resource_setup(struct lstruct lpfc_mqe *mqe;int longs; +/* Get all the module params for configuring this host */ +lpfc_get_cfgparam (phba); +/* Before proceed, wait for POST done and device ready */ rc =lpfc_sli4_post_status_check (phba);if (rc)
@@ -4902,15 +4905,6 @@ lpfc_sli4_driver_resource_setup(struct l sizeof(struct lpfc_mbox_ext_buf_ctx));INIT_LIST_HEAD (&phba->mbox_ext_buf_ctx.ext_dmabuf_list); -/* -* We need to do a READ_CONFIG mailbox command here before -* calling lpfc_get_cfgparam. For VFs this will report the -* MAX_XRI, MAX_VPI, MAX_RPI, MAX_IOCB, and MAX_VFI settings. -* All of the resources allocated -* for this Port are tied to these values. -*/ -/* Get all the module params for configuring this host */ -lpfc_get_cfgparam (phba); phba->max_vpi =LPFC_MAX_VPI ;/* This will be set to correct value after the read_config mbox */