regulator: core: set current constraints while setting machine constraints
PATCH v2 1/1 regulator: core: set current constraints while setting machine constraints
Machine constraints is configured during regulator register. If current constraints are provided through machine constraints then it is observed that sometime the current configured on rail is out of range what machine constraint has.
Set the current constraints when setting machine constraints to make sure that rail's current is within the range of given machine constraints.
---
Changes from V1:
- Correct the indentng.
- Prints warning when current-ops are not implemented.
- Set constraint current unconditionally.
- Blank line before last return.
drivers/regulator/core.c | 34 ++++++++++++++++++++++++++++++++++ 1 files changed, 34 insertions(+), 0 deletions(-)
drivers/regulator/core.c +34 -0
@@ -904,6 +904,36 @@ static int machine_constraints_voltage(struct regulator_dev *rdev,return 0 ; } +static int machine_constraints_current (struct regulator_dev *rdev, +struct regulation_constraints *constraints) +{ +struct regulator_ops *ops = rdev->desc->ops; +int ret; + +if (!constraints->min_uA && !constraints->max_uA) +return 0 ; + +if (constraints->min_uA > constraints->max_uA) { +rdev_err (rdev,"Invalid current constraints\n" ); +return -EINVAL ; + } + +if (!ops->set_current_limit || !ops->get_current_limit) { +rdev_warn (rdev,"Operation of current configuration missing\n" ); +return 0 ; + } + +/* Set regulator current in constraints range */ + ret = ops->set_current_limit (rdev, constraints->min_uA, + constraints->max_uA); +if (ret <0 ) { +rdev_err (rdev,"Failed to set current constraint, %d\n" , ret); +return ret; + } + +return 0 ; +} +/** * set_machine_constraints - sets regulator constraints * @rdev: regulator source
@@ -934,6 +964,10 @@ static int set_machine_constraints(struct regulator_dev *rdev,if (ret !=0 ) goto out; + ret =machine_constraints_current (rdev, rdev->constraints); +if (ret !=0 ) + goto out; +/* do we need to setup our suspend state */ if (rdev->constraints->initial_state) { ret =suspend_prepare (rdev, rdev->constraints->initial_state);
Signature · 1 line
1.7.1.1
Quoted 4 lines · Laxman Dewangan
Machine constraints is configured during regulator register. If current constraints are provided through machine constraints then it is observed that sometime the current configured on rail is out of range what machine constraint has.
Applied, thanks.