gspca-stk1135: Add delay after configuring clock
Subsystems (2)
PATCH 1/1 gspca-stk1135: Add delay after configuring clock
Add a small delay at the end of configure_clock() to allow sensor to initialize.
This is needed by Asus VX2S laptop webcam to detect sensor type properly (the already-supported MT9M112).
Signed-off-by Ondrej Zary <[email protected]>
--- drivers/media/usb/gspca/stk1135.c | 3 +++ 1 file changed, 3 insertions(+)
drivers/media/usb/gspca/stk1135.c +3 -0
@@ -361,6 +361,9 @@ static void stk1135_configure_clock(struct gspca_dev *gspca_dev)/* set serial interface clock divider (30MHz/0x1f*16+2) = 60240 kHz) */ reg_w (gspca_dev,STK1135_REG_SICTL +2 ,0x1f ); + +/* wait a while for sensor to catch up */ +udelay (1000 ); }static void stk1135_camera_disable (struct gspca_dev *gspca_dev)
Signature · 1 line
Ondrej Zary
Hi,
Quoted 14 lines · Ondrej Zary
Add a small delay at the end of
configure_clock()to allow sensor to initialize.
This is needed by Asus VX2S laptop webcam to detect sensor type properly (the already-supported MT9M112).Signed-off-by Ondrej Zary <[email protected]>--- drivers/media/usb/gspca/stk1135.c | 3 +++ 1 file changed, 3 insertions(+)drivers/media/usb/gspca/stk1135.c +0
-0
drivers/media/usb/gspca/stk1135.c static void stk1135_configure_clock(struct gspca_dev *gspca_dev) · line 369
Quoted 9 lines
drivers/media/usb/gspca/stk1135.c +3
-0@@ -361,6 +361,9 @@ static void stk1135_configure_clock(struct gspca_dev *gspca_dev)/* set serial interface clock divider (30MHz/0x1f*16+2) = 60240 kHz) */ reg_w (gspca_dev,STK1135_REG_SICTL +2 ,0x1f ); + +/* wait a while for sensor to catch up */ +udelay (1000 ); }static void stk1135_camera_disable (struct gspca_dev *gspca_dev)
Thanks for the patch. I've added this to my tree for 3.13 .
Regards,
Hans