staging: new asus fan driver
PATCH v2 1/1 staging: new asus fan driver
Simple driver to enable control of the fan in ASUS laptops. So far this has only been tested in ASUS Zenbook Prime UX31A, but according to some online reference [1], it should work in other models as well.
The implementation is very straight-forward, the only caveat is that the fan speed needs to be saved after it has been manually changed because it won't be reported properly until it goes back to 'auto' mode.
[1] http://forum.notebookreview.com/asus/705656-fan-control-asus-prime-ux31-ux31a-ux32a-ux32vd.html
---
Changes since v1:
* Added a missing TODO file
* Added missing Makefile
Two incarnations of this code exists [1][2], one that used ACPI methods directly, and one through WMI. Unfortunately the WMI version needs us to pass physicall addresses which is not exactly clean, and that's the only reason the code is proposed for staging.
Most likely this cannot graduate until acpica gets support to receive virtual addresses.
[1] http://article.gmane.org/gmane.linux.power-management.general/36774
[2] http://article.gmane.org/gmane.linux.kernel/1576463
drivers/staging/Kconfig | 2 + drivers/staging/Makefile | 1 + drivers/staging/asus-thermal/Kconfig | 7 ++ drivers/staging/asus-thermal/Makefile | 1 + drivers/staging/asus-thermal/TODO | 5 + drivers/staging/asus-thermal/asus_thermal.c | 166 ++++++++++++++++++++++++++++ 6 files changed, 182 insertions(+) create mode 100644 drivers/staging/asus-thermal/Kconfig create mode 100644 drivers/staging/asus-thermal/Makefile create mode 100644 drivers/staging/asus-thermal/TODO create mode 100644 drivers/staging/asus-thermal/asus_thermal.c
drivers/staging/Kconfig +2 -0
@@ -148,4 +148,6 @@ source "drivers/staging/dgnc/Kconfig" source "drivers/staging/dgap/Kconfig" +source "drivers/staging/asus-thermal/Kconfig" + endif # STAGING
drivers/staging/Makefile +1 -0
@@ -66,3 +66,4 @@ obj-$(CONFIG_USB_BTMTK) += btmtk_usb/ obj-$(CONFIG_XILLYBUS) += xillybus/ obj-$(CONFIG_DGNC) += dgnc/ obj-$(CONFIG_DGAP) += dgap/ +obj-$(CONFIG_ASUS_THERMAL) += asus-thermal/
drivers/staging/asus-thermal/Kconfig new file +7 -0
@@ -0,0 +1,7 @@ +config ASUS_THERMAL + tristate "ASUS thermal driver" + depends on THERMAL + depends on X86 + help + Enables control of the fan in ASUS laptops. +
drivers/staging/asus-thermal/Makefile new file +1 -0
@@ -0,0 +1 @@ +obj-$(CONFIG_ASUS_THERMAL) += asus_thermal.o
drivers/staging/asus-thermal/TODO new file +5 -0
@@ -0,0 +1,5 @@ +TODO: +- Get rid of virt_to_phys() + +Please send any patches to Greg Kroah-Hartman <[email protected]>, +Felipe Contreras <[email protected]>
drivers/staging/asus-thermal/asus_thermal.c new file +166 -0
166 lines not on this page · raw message
Signature · 1 line
1.8.4.2+fc1