Skip to contentSkip to conversation

fix initrd load failed

PATCH In review ChenQun 2 participants 2 messages Nov 17, 2013

lore
Share & tools
lore

ChenQun

author
#0 lore raw

PATCH 1/1 fix initrd load failed

Here's a bug, some examples are as follows:
1.Assuming Guest's filesystem size 6M.
2.For vexpress_a15, the loader_start = 2048M.
If we set guest ram_size range from 2048M+128M to 2048M+128M+6M,
then the initrd load failed.
3.For mach-virt, the loader_start = 128M.
If we set guest ram_size range from 256M to 256M+6M, then it is failed too.

So,it is a bug for load initrd max mem calculation. It should be (ram_size + loader_start - initrd_start).

---
 hw/arm/boot.c |    6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)
hw/arm/boot.c +4 -2
index 583ec79..831128d 100644
@@ -415,12 +415,14 @@ void arm_load_kernel(ARMCPU *cpu, struct arm_boot_info *info)
         if (info->initrd_filename) {
             initrd_size = load_ramdisk(info->initrd_filename,
                                        info->initrd_start,
-                                       info->ram_size -
+                                       info->ram_size +
+                                       info->loader_start -
                                        info->initrd_start);
             if (initrd_size < 0) {
                 initrd_size = load_image_targphys(info->initrd_filename,
                                                   info->initrd_start,
-                                                  info->ram_size -
+                                                  info->ram_size +
+                                                  info->loader_start -
                                                   info->initrd_start);
             }
             if (initrd_size < 0) {
Signature · 1 line
1.7.9.5
#1 lore raw
Quoted 11 lines · ChenQun

Here's a bug, some examples are as follows:
1.Assuming Guest's filesystem size 6M.
2.For vexpress_a15, the loader_start = 2048M.
If we set guest ram_size range from 2048M+128M to 2048M+128M+6M,
then the initrd load failed.
3.For mach-virt, the loader_start = 128M.
If we set guest ram_size range from 256M to 256M+6M, then it is failed too.

So,it is a bug for load initrd max mem calculation. It should be (ram_size + loader_start - initrd_start).

Yes, this is definitely a bug. The set of addresses/sizes we pass to the loader is a bit of a mess, though -- we kind of implicitly assume that "loader_start" means "bottom of RAM", and that all the ram is in one chunk. However for example realview-pbx-a9 sets loader_start to 0 when the size of that bit of RAM may be less than the total ram_size. The device tree editing code also assumes a single contiguous block of RAM...

thanks
-- PMM