arm: atmel: sam9m10g45ek: let CONFIG_SYS_NO_FLASH at proper position
PATCH 1/1 arm: atmel: sam9m10g45ek: let CONFIG_SYS_NO_FLASH at proper position
In config_cmd_default.h, it will use CONFIG_SYS_NO_FLASH to decide whether include CONFIG_CMD_FLASH and CONFIG_CMD_IMLS. So, if the CONFIG_SYS_NO_FLASH defined later than include/config_cmd_default.h, These two commands will be included always.
So move CONFIG_SYS_NO_FLASH definition to proper position.
--- include/configs/at91sam9m10g45ek.h | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-)
include/configs/at91sam9m10g45ek.h +4 -3
@@ -77,6 +77,10 @@/* * Command line configuration. */ + +/* No NOR flash */ +#define CONFIG_SYS_NO_FLASH +#include <config_cmd_default.h> #undef CONFIG_CMD_BDI#undef CONFIG_CMD_FPGA
@@ -97,9 +101,6 @@#define CONFIG_SYS_INIT_SP_ADDR \ (CONFIG_SYS_SDRAM_BASE + 4 * 1024 - GENERATED_GBL_DATA_SIZE) -/* No NOR flash */ -#define CONFIG_SYS_NO_FLASH -/* NAND flash */ #ifdef CONFIG_CMD_NAND #define CONFIG_NAND_ATMEL
Signature · 1 line
1.7.9.5
Dear Bo Shen,
Quoted 5 lines · Bo Shen
In
config_cmd_default.h, it will useCONFIG_SYS_NO_FLASHto decide whether includeCONFIG_CMD_FLASHandCONFIG_CMD_IMLS. So, if theCONFIG_SYS_NO_FLASHdefined later thaninclude/config_cmd_default.h, These two commands will be included always.
Quoted 7 lines
So move
CONFIG_SYS_NO_FLASHdefinition to proper position.Signed-off-by Bo Shen <[email protected]>---
include/configs/at91sam9m10g45ek.h| 7 ++++---1 file changed, 4 insertions(+), 3 deletions(-)
applied to u-boot-atmel/master, thanks!
Best regards,
Andreas Bie?mann