rs232 endianness on PPC
Hi,
when I write a byte on the SMC1 (MPC875) serial device (let us say 0x11) what should I expect on the output pin? First a 0 then 0, 0, 1, 0, 0, 0, 1 or the opposite. Is it different on a little endian CPU?
Bye,
Antonio.
Hai voglia di fare un viaggio, ma non sai dove andare? Scegli una delle nostre offerte HOTEL IN ITALIA E IN EUROPA da 50 euro. Prenota subito su Expedia.it e... buona vacanza!
PowerPC is only Byte swaped, not bit-swaped :)
(I thought there are only some old mainly unused Architecturs, who swap the Bits :)
The second: I think the bitorder on the rs232 is standarized :) and should be the same ... :)
Am Fri, 30 Jun 2006 21:10:31 +0200 (CEST) schrieb "[email protected]" <[email protected]> :
Quoted 25 lines
Hi,
when I write a byte on the SMC1 (MPC875) serial device (let us say
0x11) what should I expect on the output pin? First a 0 then 0, 0, 1, 0, 0, 0, 1 or the opposite. Is it different on a little endian CPU?Bye,
Antonio.Hai voglia di fare un viaggio, ma non sai dove andare? Scegli una delle nostre offerte HOTEL IN ITALIA E IN EUROPA da 50 euro. Prenota subito su Expedia.it e... buona vacanza!
http://expedia.viaggi.tiscali.it/default.aspx?eapid=330-8
_______________________________________________
Linuxppc-embedded mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-embedded
Quoted 1 line · White
PowerPC is only Byte swaped, not bit-swaped :)
PowerPC isn't byte swapped, the other world is :-)
Quoted 2 lines
The second: I think the bitorder on the rs232 is standarized :) and should be the same ... :)
RS-232 is LS bit first.
-- Dan