ASoC: wm_adsp: Remove duplicate info message for DSP RAM ready
Subsystems (3)
PATCH 1/2 ASoC: wm_adsp: Remove duplicate info message for DSP RAM ready
Signed-off-by Charles Keepax <[email protected]>
--- sound/soc/codecs/wm_adsp.c | 1 - 1 files changed, 0 insertions(+), 1 deletions(-)
sound/soc/codecs/wm_adsp.c +0 -1
@@ -1489,7 +1489,6 @@ static int wm_adsp2_ena(struct wm_adsp *dsp) }adsp_dbg (dsp,"RAM ready after %d polls\n" , count); -adsp_info (dsp,"RAM ready after %d polls\n" , count);return 0 ; }
Signature · 1 line
1.7.2.5
PATCH 2/2 ASoC: wm_adsp: Add small delay whilst polling DSP RAM start
Some devices are getting very close to the limit whilst polling the RAM start, this patch adds a small delay to this loop to give a longer startup timeout.
Signed-off-by Charles Keepax <[email protected]>
--- sound/soc/codecs/wm_adsp.c | 10 +++++++--- 1 files changed, 7 insertions(+), 3 deletions(-)
sound/soc/codecs/wm_adsp.c +7 -3
@@ -1475,13 +1475,17 @@ static int wm_adsp2_ena(struct wm_adsp *dsp)return ret;/* Wait for the RAM to start, should be near instantaneous */ - count =0 ; -do { +for (count =0 ; count <10 ; ++count) { ret =regmap_read (dsp->regmap, dsp->base +ADSP2_STATUS1 , &val);if (ret !=0 )return ret; - }while (!(val &ADSP2_RAM_RDY ) && ++count <10 ); + +if (val &ADSP2_RAM_RDY ) +break ; + +msleep (1 ); + }if (!(val &ADSP2_RAM_RDY )) {adsp_err (dsp,"Failed to start DSP RAM\n" );
Signature · 1 line
1.7.2.5
Quoted 1 line · Charles Keepax
Signed-off-by Charles Keepax <[email protected]>
Applied both, thanks.