Some questions to BATMAN

-----Ursprüngliche Nachricht-----
Von: "John Harris" <[email protected]>
Gesendet: 29.12.08 21:39:27
An: [email protected],[email protected]
Betreff: Re: [B.A.T.M.A.N.] Some questions to BATMAN

Hiii Don,

thank you very much for your reply, for your help...

Quoted 13 lines

Quoted 8 lines

1)
I will build a mesh network.. One of my router is connected to my server with the IP 129.211.186.12. I can't make
a traceroute through my router to this server. If I try to make "traceroute 129.211.186.12" from an another router I get the message:
"PING 129.211.186.12 (129.211.186.12): 56 data bytes
ping: sendto: Network is unreachable

router Server (129.211.186.12)
(batman eth0) <------------------> (batman some wireless device)

Quoted 8 lines

On the router, which firmware are you running with Batman?

When you type batmand -c -d 1 on the router /server what do you see?

What does batmand -v show on the router / server?

I have some problems with my server at the moment, I will write the output of the other commands as soon as possible...

my freifunk firmware is v1.6.29 and the batmand version is :B.A.T.M.A.N. 0.2 rv502 (compability version 3)

Quoted 16 lines

Quoted 8 lines

I can send ping requests from my server to the router and from the router to the server, but as I said, I can't make a traceroute to the server
from an another router. My question is, how can I do this ?

In OLSR it was not a problem to trace the server through the router. Should I change something in HNA messages ?

Quoted 7 lines

2)
I read the HowTO from Freifunk Leipzig about the configuration of BATMAN, look here http://wiki.leipzig.freifunk.net/BATMAN. How is the configuration
If I want to run BATMAN in Ubuntu Intrepid? How can I configure the IPTABLES ?

Quoted 8 lines

For newer batman and experimental you'll want to open up ports 4305-4307:

iptables -t filter -I INPUT 2 -p udp --dport 4305 --sport 4305 -j ACCEPT iptables -t filter -I INPUT 2 -p udp --dport 4306 --sport 4306 -j ACCEPT iptables -t filter -I INPUT 2 -p udp --dport 4307 --sport 4307 -j ACCEPT iptables -t filter -I OUTPUT 2 -p udp --dport 4305 --sport 4305 -j ACCEPT iptables -t filter -I OUTPUT 2 -p udp --dport 4306 --sport 4306 -j ACCEPT iptables -t filter -I OUTPUT 2 -p udp --dport 4307 --sport 4307 -j ACCEPT

You helped me a lot so far,thank you,
I will write the output of the commands as soon as possible...

greetings,
John

Quoted 9 lines

_______________________________________________
B.A.T.M.A.N mailing list
[email protected]
https://list.open-mesh.net/mm/listinfo/b.a.t.m.a.n