Skip to contentSkip to conversation

mx6sabresd: State that only mx6q is supported in SPL

PATCH New Fabio Estevam 2 participants 2 messages Nov 15, 2014 – Nov 20, 2014

lore
Share & tools
lore

Fabio Estevam

author
#0 lore raw

PATCH 1/1 mx6sabresd: State that only mx6q is supported in SPL

From: Fabio Estevam <[email protected]>

Make clear that current SPL code only supports the mx6q variant.

Signed-off-by Fabio Estevam <[email protected]>
---
 board/freescale/mx6sabresd/mx6sabresd.c | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)
board/freescale/mx6sabresd/mx6sabresd.c +2 -4
index 343c3b6..d5cd37d 100644
@@ -754,10 +754,8 @@ static void gpr_init(void)
 }
 
 /*
- * This section require the differentiation
- * between iMX6 Sabre Families.
- * But for now, it will configure only for
- * SabreSD.
+ * This section requires the differentiation between iMX6 Sabre boards, but
+ * for now, it will configure only for the mx6q variant.
  */
 static void spl_dram_init(void)
 {
Signature · 1 line
1.9.1
#1 lore raw

PATCH 1/1 mx6sabresd: State that only mx6q is supported in SPL

Quoted 6 lines · Fabio Estevam

From: Fabio Estevam <[email protected]>

Make clear that current SPL code only supports the mx6q variant.

Signed-off-by Fabio Estevam <[email protected]>

---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================