x86: ich-spi: Set the rx operation mode for ich 7
PATCH v3 1/2 x86: ich-spi: Set the rx operation mode for ich 7
ICH 7 SPI controller only supports array read command (03h). Fast array read command (0Bh) is not supported.
Signed-off-by Bin Meng <[email protected]>
Acked-by Simon Glass <[email protected]>
Tested-by Simon Glass <[email protected]>
---
Changes in v3: None
RESEND of v2 patch @ http://patchwork.ozlabs.org/patch/405752/
drivers/spi/ich.c | 4 ++++ 1 file changed, 4 insertions(+)
drivers/spi/ich.c +4 -0
@@ -141,6 +141,10 @@ struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs, ich->slave.max_write_size = ctlr.databytes; ich->speed = max_hz; +/* ICH 7 SPI controller only supports array read command */ +if (ctlr.ich_version ==7 ) + ich->slave.op_mode_rx =SPI_OPM_RX_AS ; +return &ich->slave; }
Signature · 1 line
1.8.2.1