ASoC: fsl_ssi: Don't try to round-up for PM divisor calculation
Subsystems (3)
Nicolin Chen
reviewerPATCH 1/1 ASoC: fsl_ssi: Don't try to round-up for PM divisor calculation
According to i.MX6 Series Reference Manual, the formula to calculate the sys clock is
sysclk rate = bclk rate * (div2 + 1) * (7 * psr + 1) * (pm + 1) * 2
Commit aafa85e71a75 ("ASoC: fsl_ssi: Add DAI master mode support for SSI on i.MX series") added the divisor calculation which relies on the clk_round_rate(). However, at that time, clk_round_rate() didn't provide closest clock rates for some cases because it might not use a correct rounding policy. So using the original formula (pm + 1) for PM divisor was not able to give us a desired clock rate. And then we used (pm + 2) to do the trick.
However, the clk-divider driver has been refined a lot since commit b11d282dbea2 ("clk: divider: fix rate calculation for fractional rates") Now using (pm + 2) trick would result an incorrect clock rate.
So this patch fixes the problem by removing the useless trick.
---
[ I also checked that only 3.18 stable tree has the refinements for
clk-divider driver, so I guess it might not be able to apply to previous long-term trees if being treated as bug fix. -- Nicolin ]
sound/soc/fsl/fsl_ssi.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
sound/soc/fsl/fsl_ssi.c +1 -1
@@ -603,7 +603,7 @@ static int fsl_ssi_set_bclk(struct snd_pcm_substream *substream, factor = (div2 +1 ) * (7 * psr +1 ) *2 ;for (i =0 ; i <255 ; i++) { - tmprate = freq * factor * (i +2 ); + tmprate = freq * factor * (i +1 );if (baudclk_is_used) clkrate =clk_get_rate (ssi_private->baudclk);
Signature · 1 line
1.9.1
Mark Brown
maintainerQuoted 2 lines · Nicolin Chen
According to i.MX6 Series Reference Manual, the formula to calculate the sys clock is
This doesn't apply against current code, pleae check and resend.
Nicolin Chen
reviewerQuoted 5 lines · Mark Brown
Quoted 2 lines · Nicolin Chen
According to i.MX6 Series Reference Manual, the formula to calculate the sys clock is
This doesn't apply against current code, pleae check and resend.
That's strange...I downloaded it from Patchwork and tried to apply it on the latest for-next. It doesn't give me any error...
And I git-formated a new one but it doesn't look so different from the one in the maillist...
Thank you
Nicolin