extcon-axp288: Add axp288 extcon driver support
Subsystems (3)
PATCH 2/2 extcon-axp288: Add axp288 extcon driver support
This patch adds the extcon support for AXP288 PMIC which has the BC1.2 charger detection capability. Additionally it also adds the USB mux switching support b/w SOC and PMIC based on GPIO control.
Signed-off-by Ramakrishna Pallala <[email protected]>
--- drivers/extcon/Kconfig | 7 + drivers/extcon/Makefile | 1 + drivers/extcon/extcon-axp288.c | 479 ++++++++++++++++++++++++++++++++++++++++ 3 files changed, 487 insertions(+) create mode 100644 drivers/extcon/extcon-axp288.c
drivers/extcon/Kconfig +7 -0
@@ -93,4 +93,11 @@ config EXTCON_SM5502 Silicon Mitus SM5502. The SM5502 is a USB port accessory detector and switch. +config EXTCON_AXP288 + tristate "AXP288 EXTCON support" + depends on MFD_AXP20X && USB_PHY + help + Say Y here to enable support for USB peripheral detection + and USB MUX switching by AXP288 PMIC. + endif # MULTISTATE_SWITCH
drivers/extcon/Makefile +1 -0
@@ -12,3 +12,4 @@ obj-$(CONFIG_EXTCON_MAX8997) += extcon-max8997.o obj-$(CONFIG_EXTCON_PALMAS) += extcon-palmas.o obj-$(CONFIG_EXTCON_RT8973A) += extcon-rt8973a.o obj-$(CONFIG_EXTCON_SM5502) += extcon-sm5502.o +obj-$(CONFIG_EXTCON_AXP288) += extcon-axp288.o
drivers/extcon/extcon-axp288.c new file +479 -0
479 lines not on this page · raw message
Signature · 1 line
1.7.9.5