Skip to contentSkip to conversation

spmi: Question about qpnpint_irq_set_type implement

PATCH Axel Lin 1 participant 1 message Jun 26, 2015 SPMI

lore
Share & tools
lore

Axel Lin

author
#0 lore raw

Hi,
Current implementation in qpnpint_irq_set_type() will set (1 << irq) bit for type.polarity_high/type.polarity_low but never clear this bit. I'm wondering if it is intentional because the value write to QPNPINT_REG_SET_TYPE register depends on it's original value.

Maybe it needs below changes, comments?

drivers/spmi/spmi-pmic-arb.c +10 -2
index 6ea6eab..fe59cf4 100644
@@ -557,18 +557,26 @@ static int qpnpint_irq_set_type(struct irq_data *d, unsigned int flow_type)
 		type.type |= 1 << irq;
 		if (flow_type & IRQF_TRIGGER_RISING)
 			type.polarity_high |= 1 << irq;
+		else
+			type.polarity_high &= ~(1 << irq);
+
 		if (flow_type & IRQF_TRIGGER_FALLING)
 			type.polarity_low  |= 1 << irq;
+		else
+			type.polarity_low &= ~(1 << irq);
 	} else {
 		if ((flow_type & (IRQF_TRIGGER_HIGH)) &&
 		    (flow_type & (IRQF_TRIGGER_LOW)))
 			return -EINVAL;
 
 		type.type &= ~(1 << irq); /* level trig */
-		if (flow_type & IRQF_TRIGGER_HIGH)
+		if (flow_type & IRQF_TRIGGER_HIGH) {
 			type.polarity_high |= 1 << irq;
-		else
+			type.polarity_low &= ~(1 << irq);
+		} else {
+			type.polarity_high &= ~(1 << irq);
 			type.polarity_low  |= 1 << irq;
+		}
 	}
 
 	qpnpint_spmi_write(d, QPNPINT_REG_SET_TYPE, &type, sizeof(type));