Staging: rtl8712: ieee80211.h: Coding style warnings fix for block comments
PATCH 1/1 Staging: rtl8712: ieee80211.h: Coding style warnings fix for block comments
This patch is to the ieee80211.h that fixes up following warnings reported by checkpatch.pl :
-Block comments use * on subsequent lines -Block comments use a trailing */ on a separate line
Signed-off-by Punit Vara <[email protected]>
--- drivers/staging/rtl8712/ieee80211.h | 59 +++++++++++++++++++++---------------- 1 file changed, 33 insertions(+), 26 deletions(-)
drivers/staging/rtl8712/ieee80211.h +33 -26
@@ -119,13 +119,15 @@ struct ieee_param { };#define IEEE80211_DATA_LEN 2304 -/* Maximum size for the MA-UNITDATA primitive, 802.11 standard section -6.2.1.1.2. - -The figure in section 7.1.2 suggests a body size of up to 2312 -bytes is allowed, which is a bit confusing, I suspect this -represents the 2304 bytes of real data, plus a possible 8 bytes of -WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro) */ +/* +* Maximum size for the MA-UNITDATA primitive, 802.11 standard section +* 6.2.1.1.2. +* +* The figure in section 7.1.2 suggests a body size of up to 2312 +* bytes is allowed, which is a bit confusing, I suspect this +* represents the 2304 bytes of real data, plus a possible 8 bytes of +* WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro) +*/ #define IEEE80211_HLEN 30#define IEEE80211_FRAME_LEN (IEEE80211_DATA_LEN + IEEE80211_HLEN)
@@ -403,9 +405,11 @@ struct ieee80211_snap_hdr { -/* NOTE: This data is for statistical purposes; not all hardware provides this +/* +* NOTE: This data is for statistical purposes; not all hardware provides this * information for frames received. Not setting these will not cause -* any adverse affects. */ +* any adverse affects. +*/ struct ieee80211_rx_stats {s8 rssi;u8 signal;
@@ -417,10 +421,12 @@ struct ieee80211_rx_stats {u16 len; }; -/* IEEE 802.11 requires that STA supports concurrent reception of at least +/* +* IEEE 802.11 requires that STA supports concurrent reception of at least * three fragmented frames. This define can be increased to support more * concurrent frames, but it should be noted that each entry can consume about -* 2 kB of RAM and increasing cache size will slow down frame reassembly. */ +* 2 kB of RAM and increasing cache size will slow down frame reassembly. +*/ #define IEEE80211_FRAG_CACHE_LEN 4struct ieee80211_frag_entry {
@@ -510,19 +516,18 @@ struct ieee80211_security { } __packed;/* - -802.11 data frame from AP - -,-------------------------------------------------------------------. -Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 | -|------|------|---------|---------|---------|------|---------|------| -Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs | -| | tion | (BSSID) | | | ence | data | | -`-------------------------------------------------------------------' - -Total: 28-2340 bytes - -*/ +* +* 802.11 data frame from AP +* +* ,-------------------------------------------------------------------. +* Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 | +* |------|------|---------|---------|---------|------|---------|------| +* Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs | +* | | tion | (BSSID) | | | ence | data | | +* `-------------------------------------------------------------------' +* +* Total: 28-2340 bytes +*/ struct ieee80211_header_data {u16 frame_ctl;
@@ -625,10 +630,12 @@ struct ieee80211_txb {/* SWEEP TABLE ENTRIES NUMBER*/ #define MAX_SWEEP_TAB_ENTRIES 42#define MAX_SWEEP_TAB_ENTRIES_PER_PACKET 7 -/* MAX_RATES_LENGTH needs to be 12. The spec says 8, and many APs +/* +* MAX_RATES_LENGTH needs to be 12. The spec says 8, and many APs * only use 8, and then use extended rates for the remaining supported * rates. Other APs, however, stick all of their supported rates on the -* main rates information element... */ +* main rates information element... +*/ #define MAX_RATES_LENGTH ((u8)12)#define MAX_RATES_EX_LENGTH ((u8)16)#define MAX_NETWORK_COUNT 128
Signature · 1 line
2.5.2