clocksource/drivers/tango-xtal: Replace code by clocksource_mmio_init
PATCH v2 1/1 clocksource/drivers/tango-xtal: Replace code by clocksource_mmio_init
The current code to initialize, register and read the clocksource is already factored out in mmio.c via the clocksource_mmio_init function.
Factor out the code with the clocksource_mmio_init function.
Signed-off-by Daniel Lezcano <[email protected]>
--- drivers/clocksource/Kconfig | 1 + drivers/clocksource/tango_xtal.c | 18 +++--------------- 2 files changed, 4 insertions(+), 15 deletions(-)
drivers/clocksource/Kconfig +1 -0
@@ -333,6 +333,7 @@ config CLKSRC_TANGO_XTAL bool "Clocksource for Tango SoC" if COMPILE_TEST depends on ARM select CLKSRC_OF + select CLKSRC_MMIO help This enables the clocksource for Tango SoC
drivers/clocksource/tango_xtal.c +3 -15
@@ -19,19 +19,6 @@ static u64 notrace read_sched_clock(void)return read_xtal_counter (); } -static cycle_t read_clocksource (struct clocksource *cs) -{ -return read_xtal_counter (); -} - -static struct clocksource tango_xtal = { - .name ="tango-xtal" , - .rating =350 , - .read = read_clocksource, - .mask =CLOCKSOURCE_MASK (32 ), - .flags =CLOCK_SOURCE_IS_CONTINUOUS , -}; -static void __init tango_clocksource_init (struct device_node *np) {struct clk *clk;
@@ -53,8 +40,9 @@ static void __init tango_clocksource_init(struct device_node *np) delay_timer.freq = xtal_freq; delay_timer.read_current_timer = read_xtal_counter; - ret =clocksource_register_hz (&tango_xtal, xtal_freq); -if (ret !=0 ) { + ret =clocksource_mmio_init (xtal_in_cnt,"tango-xtal" , xtal_freq,350 , +32 , clocksource_mmio_readl_up); +if (!ret) {pr_err ("%s: registration failed\n" , np->full_name);return ; }
Signature · 1 line
1.9.1