patch "usb: gadget: atmel_usba_udc: Expose correct device speed" added to usb-linus

This is a note to let you know that I've just added the patch titled

usb: gadget: atmel_usba_udc: Expose correct device speed

to my usb git tree which can be found at
git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb.git
in the usb-linus branch.

The patch will show up in the next release of the linux-next tree (usually sometime within the next 24 hours during the week.)

The patch will hopefully also be merged in Linus's tree for the next -rc kernel release.

If you have any questions about this process, please let me know.

From: Douglas Gilbert <[email protected]>
Date: Mon, 16 Nov 2015 19:22:08 +0100
Subject: usb: gadget: atmel_usba_udc: Expose correct device speed

Following changes that appeared in lk 4.0.0, the gadget udc driver for some ARM based Atmel SoCs (e.g. at91sam9x5 and sama5d3 families) incorrectly deduced full-speed USB link speed even when the hardware had negotiated a high-speed link. The fix is to make sure that the UDPHS Interrupt Enable Register value does not mask the SPEED bit in the Interrupt Status Register.

For a mass storage gadget this problem lead to failures when the host had a USB 3 port with the xhci_hcd driver. If the host was a USB 2 port using the ehci_hcd driver then the mass storage gadget worked (but probably at a lower speed than it should have).

---
 drivers/usb/gadget/udc/atmel_usba_udc.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

index f0f2b066ac08..f92f5aff0dd5 100644
@@ -1633,7 +1633,7 @@ static irqreturn_t usba_udc_irq(int irq, void *devid)
 	spin_lock(&udc->lock);
 
 	int_enb = usba_int_enb_get(udc);
-	status = usba_readl(udc, INT_STA) & int_enb;
+	status = usba_readl(udc, INT_STA) & (int_enb | USBA_HIGH_SPEED);
 	DBG(DBG_INT, "irq, status=%#08x\n", status);
 
 	if (status & USBA_DET_SUSPEND) {

2.6.2