patch "usb: host: xhci-rcar: Avoid long wait in xhci_reset()" added to usb-next

This is a note to let you know that I've just added the patch titled

usb: host: xhci-rcar: Avoid long wait in xhci_reset()

to my usb git tree which can be found at
git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/usb.git
in the usb-next branch.

The patch will show up in the next release of the linux-next tree (usually sometime within the next 24 hours during the week.)

The patch will also be merged in the next major kernel release during the merge window.

If you have any questions about this process, please let me know.

From: Yoshihiro Shimoda <[email protected]>
Date: Fri, 6 May 2016 15:20:11 +0900
Subject: usb: host: xhci-rcar: Avoid long wait in xhci_reset()

The firmware of R-Car USB 3.0 host controller will control the reset. So, if the xhci driver doesn't do firmware downloading (e.g. kernel configuration is CONFIG_USB_XHCI_PLATFORM=y and CONFIG_USB_XHCI_RCAR is not set), the reset of USB 3.0 host controller doesn't work correctly. Then, the host controller will cause long wait in xhci_reset() because the CMD_RESET bit of op_regs->command is not cleared for 10 seconds.

So, this patch modifies the Kconfig to enable both CONFIG_USB_XHCI_PLATFORM and CONFIG_USB_XHCI_RCAR.

---
 drivers/usb/host/Kconfig | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

index 3050b18b2447..e9d4dde3e9b3 100644
@@ -35,6 +35,7 @@ config USB_XHCI_PCI
 
 config USB_XHCI_PLATFORM
 	tristate "Generic xHCI driver for a platform device"
+	select USB_XHCI_RCAR if ARCH_RENESAS
 	---help---
 	  Adds an xHCI host driver for a generic platform device, which
 	  provides a memory space and an irq.

@@ -63,7 +64,7 @@ config USB_XHCI_MVEBU
 
 config USB_XHCI_RCAR
 	tristate "xHCI support for Renesas R-Car SoCs"
-	select USB_XHCI_PLATFORM
+	depends on USB_XHCI_PLATFORM
 	depends on ARCH_RENESAS || COMPILE_TEST
 	---help---
 	  Say 'Y' to enable the support for the xHCI host controller

2.8.2