usb: gadget: net2280: add USB2380 support
PATCH 1/1 usb: gadget: net2280: add USB2380 support
The PLX USB2380 is a PCIe version of the NET2280 and behaves more like the USB338x but without the USB3.0 superspeed support.
This was tested with g_ether, g_serial, g_mass_storage on a Gateworks Ventana GW2383.
Cc Justin DeFields <[email protected]>
Signed-off-by Tim Harvey <[email protected]>
--- drivers/usb/gadget/udc/Kconfig | 4 +++- drivers/usb/gadget/udc/net2280.c | 51 +++++++++++++++++++++++----------------- drivers/usb/gadget/udc/net2280.h | 1 + 3 files changed, 34 insertions(+), 22 deletions(-)
drivers/usb/gadget/udc/Kconfig +3 -1
@@ -312,7 +312,7 @@ config USB_NET2272_DMA If unsure, say "N" here. The driver works fine in PIO mode. config USB_NET2280 - tristate "NetChip 228x / PLX USB338x" + tristate "NetChip NET228x / PLX USB3x8x" depends on PCI help NetChip 2280 / 2282 is a PCI based USB peripheral controller which
@@ -322,6 +322,8 @@ config USB_NET2280 (for control transfers) and several endpoints with dedicated functions. + PLX 2380 is a PCIe version of the PLX 2380. + PLX 3380 / 3382 is a PCIe based USB peripheral controller which supports full, high speed USB 2.0 and super speed USB 3.0 data transfers.
drivers/usb/gadget/udc/net2280.c +30 -21
180 lines not on this page · raw message
drivers/usb/gadget/udc/net2280.h +1 -0
@@ -47,6 +47,7 @@ set_idx_reg(struct net2280_regs __iomem *regs, u32 index, u32 value)#define PLX_LEGACY BIT(0)#define PLX_2280 BIT(1)#define PLX_SUPERSPEED BIT(2) +#define PLX_PCIE BIT(3)#define REG_DIAG 0x0#define RETRY_COUNTER 16
Signature · 1 line
1.9.1