Revert "hwmon: Add Power8 OCC hwmon driver"

deleted file mode 100644
index 9aab2df..0000000
@@ -1,13 +0,0 @@
-HWMON i2c driver for IBM POWER CPU OCC (On Chip Controller)
-
-Required properties:
- - compatible: must be "ibm,power8-occ-i2c"
- - reg: physical address
-
-Example:
-i2c3: i2c-bus@100 {
-	occ@50 {
-		compatible = "ibm,occ-i2c";
-		reg = <0x50>;
-	};
-};

index d4de8d5..367496c 100644
@@ -1226,19 +1226,6 @@ config SENSORS_NSA320
 	  This driver can also be built as a module. If so, the module
 	  will be called nsa320-hwmon.
 
-config SENSORS_POWER8_OCC_I2C
-	tristate "Power8 On Chip Controller i2c driver"
-	depends on I2C
-	help
-	  If you say yes here you get support to monitor Power8 CPU
-	  sensors via the On Chip Controller (OCC) over the i2c bus.
-
-	  Generally this is used by management controllers such as a BMC
-	  on an OpenPower system.
-
-	  This driver can also be built as a module. If so, the module
-	  will be called power8_occ_i2c.
-
 config SENSORS_PCF8591
 	tristate "Philips PCF8591 ADC/DAC"
 	depends on I2C

index 4455478..d7ccb02 100644
@@ -128,7 +128,6 @@ obj-$(CONFIG_SENSORS_NCT7802)	+= nct7802.o
 obj-$(CONFIG_SENSORS_NCT7904)	+= nct7904.o
 obj-$(CONFIG_SENSORS_NSA320)	+= nsa320-hwmon.o
 obj-$(CONFIG_SENSORS_NTC_THERMISTOR)	+= ntc_thermistor.o
-obj-$(CONFIG_SENSORS_POWER8_OCC_I2C)	+= power8_occ_i2c.o
 obj-$(CONFIG_SENSORS_PC87360)	+= pc87360.o
 obj-$(CONFIG_SENSORS_PC87427)	+= pc87427.o
 obj-$(CONFIG_SENSORS_PCF8591)	+= pcf8591.o