scsi: ufs: optimize system suspend handling

Consider following sequence of events:
1. UFS is runtime suspended, link_state = Hibern8, device_state = sleep
2. System goes into system suspend, ufshcd_system_suspend() brings both link and device to active state and then puts the device in Power_Down state and link in OFF state.
3. System resumes at some later point in time, ufshcd_system_resume() doesn't do anything as UFS state is runtime suspended. Note that link is still on OFF state and device is in Power_Down state.
4. Now system again goes into suspend without any UFS accesses before it. ufshcd_system_suspend() again brings both link and device to active state and then puts the device in Power_Down state and link if OFF state. But it's unnecessary to bring the link & device in active state as both link and device are already in desired low power states. This change fixes this issue by adding proper state checks in ufshcd_system_suspend().

---
 drivers/scsi/ufs/ufshcd.c | 15 ++++++---------
 1 file changed, 6 insertions(+), 9 deletions(-)

index b826078..4b6cc07 100644
@@ -6272,16 +6272,13 @@ int ufshcd_system_suspend(struct ufs_hba *hba)
 	if (!hba || !hba->is_powered)
 		return 0;
 
-	if (pm_runtime_suspended(hba->dev)) {
-		if (hba->rpm_lvl == hba->spm_lvl)
-			/*
-			 * There is possibility that device may still be in
-			 * active state during the runtime suspend.
-			 */
-			if ((ufs_get_pm_lvl_to_dev_pwr_mode(hba->spm_lvl) ==
-			    hba->curr_dev_pwr_mode) && !hba->auto_bkops_enabled)
-				goto out;
+	if ((ufs_get_pm_lvl_to_dev_pwr_mode(hba->spm_lvl) ==
+	     hba->curr_dev_pwr_mode) &&
+	    (ufs_get_pm_lvl_to_link_pwr_state(hba->spm_lvl) ==
+	     hba->uic_link_state))
+		goto out;
 
+	if (pm_runtime_suspended(hba->dev)) {
 		/*
 		 * UFS device and/or UFS link low power states during runtime
 		 * suspend seems to be different than what is expected during

The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project