How to make I2C probe like commands working in u-boot
Hi,
Am trying to validate I2C peripheral on xilinx zynq zc702 evaluation
board in u-boot. When am trying to run the command like i2c probe and i2c write am facing the issue like i2c commands are not known. Please can someone tell me how to enable these commands to use it in u-boot
--
View this message in context: http://u-boot.10912.n7.nabble.com/How-to-make-I2C-probe-like-commands-working-in-u-boot-tp276105.html
Sent from the U-Boot mailing list archive at Nabble.com.
Hello lsunkara,
Am 08.12.2016 um 06:37 schrieb lsunkara:
Quoted 5 lines
Hi,
Am trying to validate I2C peripheral on xilinx zynq zc702 evaluation
board in u-boot. When am trying to run the command like i2c probe and i2c write am facing the issue like i2c commands are not known. Please can someone tell me how to enable these commands to use it in u-boot
Activate the CMD_I2C symbol through "make menuconfig", or if you have an old version of U-Boot add it to your board config file.
bye,
Heiko
Quoted 11 lines
--
View this message in context: http://u-boot.10912.n7.nabble.com/How-to-make-I2C-probe-like-commands-working-in-u-boot-tp276105.html
Sent from the U-Boot mailing list archive at Nabble.com.
_______________________________________________
U-Boot mailing list
U-Boot at lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
Signature · 2 lines
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany