Patch "dmaengine: mv_xor_v2: enable XOR engine after its configuration" has been added to the 4.9-stable tree

This is a note to let you know that I've just added the patch titled

dmaengine: mv_xor_v2: enable XOR engine after its configuration

to the 4.9-stable tree which can be found at:
http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary

The filename of the patch is:
dmaengine-mv_xor_v2-enable-xor-engine-after-its-configuration.patch
and it can be found in the queue-4.9 subdirectory.

If you, or anyone else, feels it should not be added to the stable tree, please let <[email protected]> know about it.

From: Hanna Hawa <[email protected]>
Date: Fri, 5 May 2017 11:57:47 +0200
Subject: dmaengine: mv_xor_v2: enable XOR engine after its configuration

From: Hanna Hawa <[email protected]>

commit ab2c5f0a77fe49bdb6e307b397496373cb47d2c2 upstream.

The engine was enabled prior to its configuration, which isn't correct. This patch relocates the activation of the XOR engine, to be after the configuration of the XOR engine.

---
 drivers/dma/mv_xor_v2.c |    6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

@@ -653,9 +653,6 @@ static int mv_xor_v2_descq_init(struct m
 	writel((xor_dev->hw_desq & 0xFFFF00000000) >> 32,
 	       xor_dev->dma_base + MV_XOR_V2_DMA_DESQ_BAHR_OFF);
 
-	/* enable the DMA engine */
-	writel(0, xor_dev->dma_base + MV_XOR_V2_DMA_DESQ_STOP_OFF);
-
 	/*
 	 * This is a temporary solution, until we activate the
 	 * SMMU. Set the attributes for reading & writing data buffers

@@ -699,6 +696,9 @@ static int mv_xor_v2_descq_init(struct m
 	reg |= MV_XOR_V2_GLOB_PAUSE_AXI_TIME_DIS_VAL;
 	writel(reg, xor_dev->glob_base + MV_XOR_V2_GLOB_PAUSE);
 
+	/* enable the DMA engine */
+	writel(0, xor_dev->dma_base + MV_XOR_V2_DMA_DESQ_STOP_OFF);
+
 	return 0;
 }
 

Patches currently in stable-queue which might be from [email protected] are

queue-4.9/dmaengine-mv_xor_v2-enable-xor-engine-after-its-configuration.patch