Skip to contentSkip to conversation

Using a gitweb interface as a PREMIRROR

DISCUSSION Darcy Watkins 1 participant 1 message Jan 3, 2018

lore
Share & tools
lore
#0 lore raw

Hi,

Has anyone used a gitweb interface as a PREMIRROR?

The idea is to version control a GIT repo by adding the tarballs to it as needed (i.e. to track the changes, etc), and then have a yocto build access it using the gitweb interface.

I have tried variations of premirror URL expressions like below...

PREMIRRORS_prepend = "\
http://.*/.* http://myhost.mydomain/gitweb?p=mydownloads.git%3Ba=blob_p
lain%3Bhb=refs/heads/master%3Bf=BASENAME \n \
"

And wind up with non working results. In some cases, I get the basename of the tarball tacked onto the mydownloads.git. Seems the only way to avoid that is to have the f=BASENAME at the end. If I use ';' instead of '%3B', the URL gets parsed and broken up by the fetcher logic. If I use '%3B', then it results in a "not found" error. Also I notice that the 'gitweb?p=' gets escaped to 'gitweb%3Fp%3D' even when I am able to get the rest of the ';' and '=' to pass through.

Anyone gotten such a scheme to work?

Signature · 14 lines
Regards,
 
Darcy
 
Darcy Watkins ::  Senior Staff Engineer, Firmware
 
SIERRA
WIRELESS
Direct  +1 604 233 7989   ::  Fax  +1 604 231 1109  ::  Main  +
1 604 231 1100
13811 Wireless Way  :: Richmond, BC Canada V6V 3A4
[P1]
dwa
[email protected] :: www.sierrawireless.com