Patch "Documentation: pinctrl: palmas: Add ti,palmas-powerhold-override property definition" has been added to the 3.18-stable tree
Subsystems (3)
This is a note to let you know that I've just added the patch titled
Documentation: pinctrl: palmas: Add ti,palmas-powerhold-override property definition
to the 3.18-stable tree which can be found at:
http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary
The filename of the patch is:
documentation-pinctrl-palmas-add-ti-palmas-powerhold-override-property-definition.patch
and it can be found in the queue-3.18 subdirectory.
If you, or anyone else, feels it should not be added to the stable tree, please let <[email protected]> know about it.
Quoted 1 line
From
0ea66f76ba17a4b229caaadd77de694111b21769Mon Sep 17 00:00:00 2001
From: Keerthy <[email protected]>
Date: Mon, 28 Nov 2016 09:31:58 +0530
Subject: Documentation: pinctrl: palmas: Add ti,palmas-powerhold-override property definition
From: Keerthy <[email protected]>
commit 0ea66f76ba17a4b229caaadd77de694111b21769 upstream.
GPIO7 is configured in POWERHOLD mode which has higher priority over DEV_ON bit and keeps the PMIC supplies on even after the DEV_ON bit is turned off. This property enables driver to over ride the POWERHOLD value to GPIO7 so as to turn off the PMIC in power off scenarios.
--- Documentation/devicetree/bindings/pinctrl/pinctrl-palmas.txt | 9 +++++++++ 1 file changed, 9 insertions(+)
Documentation/devicetree/bindings/pinctrl/pinctrl-palmas.txt +9 -0
@@ -35,6 +35,15 @@ Optional properties: - ti,palmas-enable-dvfs2: Enable DVFS2. Configure pins for DVFS2 mode. Selection primary or secondary function associated to GPADC_START and SYSEN2 pin/pad for DVFS2 interface +- ti,palmas-override-powerhold: This is applicable for PMICs for which + GPIO7 is configured in POWERHOLD mode which has higher priority + over DEV_ON bit and keeps the PMIC supplies on even after the DEV_ON + bit is turned off. This property enables driver to over ride the + POWERHOLD value to GPIO7 so as to turn off the PMIC in power off + scenarios. So for GPIO7 if ti,palmas-override-powerhold is set + then the GPIO_7 field should never be muxed to anything else. + It should be set to POWERHOLD by default and only in case of + power off scenarios the driver will over ride the mux value. This binding uses the following generic properties as defined in pinctrl-bindings.txt:
Patches currently in stable-queue which might be from [email protected] are
queue-3.18/documentation-pinctrl-palmas-add-ti-palmas-powerhold-override-property-definition.patch queue-3.18/arm-dts-dra7-add-power-hold-and-power-controller-properties-to-palmas.patch