FAILED: patch "[PATCH] usb: xhci: fix uninitialized completion when USB3 port got" failed to apply to 4.14-stable tree

The patch below does not apply to the 4.14-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From: Aaron Ma <[email protected]>
Date: Fri, 9 Nov 2018 17:21:20 +0200
Subject: [PATCH] usb: xhci: fix uninitialized completion when USB3 port got
wrong status

Realtek USB3.0 Card Reader [0bda:0328] reports wrong port status on Cannon lake PCH USB3.1 xHCI [8086:a36d] after resume from S3, after clear port reset it works fine.

Since this device is registered on USB3 roothub at boot, when port status reports not superspeed, xhci_get_port_status will call an uninitialized completion in bus_state[0].
Kernel will hang because of NULL pointer.

Restrict the USB2 resume status check in USB2 roothub to fix hang issue.

index 12eea73d9f20..60e4ac7ae4f8 100644
@@ -876,7 +876,7 @@ static u32 xhci_get_port_status(struct usb_hcd *hcd,
 			status |= USB_PORT_STAT_SUSPEND;
 	}
 	if ((raw_port_status & PORT_PLS_MASK) == XDEV_RESUME &&
-		!DEV_SUPERSPEED_ANY(raw_port_status)) {
+		!DEV_SUPERSPEED_ANY(raw_port_status) && hcd->speed < HCD_USB3) {
 		if ((raw_port_status & PORT_RESET) ||
 				!(raw_port_status & PORT_PE))
 			return 0xffffffff;

index 730a6ecd85fc..250b758efe9f 100644
@@ -1646,7 +1646,7 @@ static void handle_port_status(struct xhci_hcd *xhci,
 	 * RExit to a disconnect state).  If so, let the the driver know it's
 	 * out of the RExit state.
 	 */
-	if (!DEV_SUPERSPEED_ANY(portsc) &&
+	if (!DEV_SUPERSPEED_ANY(portsc) && hcd->speed < HCD_USB3 &&
 			test_and_clear_bit(hcd_portnum,
 				&bus_state->rexit_ports)) {
 		complete(&bus_state->rexit_done[hcd_portnum]);