arm: dts: Stratix10: Add QSPI node
PATCH 1/1 arm: dts: Stratix10: Add QSPI node
Add QSPI device tree to Stratix 10. Sync from Linux Stratix 10 dts.
Tested on Stratix 10 SoC devkit.SOCFPGA_STRATIX10 # sf probe 0:0
SF: Detected mt25qu02g with page size 256 Bytes, erase size 64 KiB, total 256 MiB
--- arch/arm/dts/socfpga_stratix10.dtsi | 16 ++++++++++++++++ arch/arm/dts/socfpga_stratix10_socdk.dts | 21 +++++++++++++++++++++ 2 files changed, 37 insertions(+)
arch/arm/dts/socfpga_stratix10.dtsi +16 -0
@@ -391,5 +391,21 @@ resets = <&rst WATCHDOG3_RESET>; status = "disabled"; }; + + qspi: spi at ff8d2000 { + compatible = "cdns,qspi-nor"; + #address-cells = <1>; + #size-cells = <0>; + reg = <0xff8d2000 0x100>, + <0xff900000 0x100000>; + interrupts = <0 3 4>; + cdns,fifo-depth = <128>; + cdns,fifo-width = <4>; + cdns,trigger-address = <0x00000000>; + bus-num = <0>; + /*spi-max-frequency = <50000000>;*/ + status = "disabled"; + u-boot,dm-pre-reloc; + }; }; };
arch/arm/dts/socfpga_stratix10_socdk.dts +21 -0
@@ -10,6 +10,7 @@ aliases { serial0 = &uart0; + spi0 = &qspi; }; chosen {
@@ -87,6 +88,26 @@ smplsel = <0>; }; +&qspi { + status = "okay"; + + flash at 0 { + u-boot,dm-pre-reloc; + #address-cells = <1>; + #size-cells = <1>; + compatible = "spi-flash"; + reg = <0>; /* chip select */ + spi-max-frequency = <50000000>; + + page-size = <256>; + block-size = <16>; /* 2^16, 64KB */ + cdns,tshsl-ns = <50>; + cdns,tsd2d-ns = <50>; + cdns,tchsh-ns = <4>; + cdns,tslch-ns = <4>; + }; +}; + &uart0 { status = "okay"; };
Signature · 1 line
2.19.0
PATCH 1/1 arm: dts: Stratix10: Add QSPI node
Quoted 25 lines · Ley Foon Tan
Add QSPI device tree to Stratix 10. Sync from Linux Stratix 10 dts.
Tested on Stratix 10 SoC devkit.
SOCFPGA_STRATIX10# sf probe 0:0
SF: Detected mt25qu02g with page size 256 Bytes, erase size 64 KiB, total 256 MiBSigned-off-by Ley Foon Tan <[email protected]>--- arch/arm/dts/socfpga_stratix10.dtsi | 16 ++++++++++++++++ arch/arm/dts/socfpga_stratix10_socdk.dts | 21 +++++++++++++++++++++ 2 files changed, 37 insertions(+)arch/arm/dts/socfpga_stratix10.dtsi +3
-0@@ -391,5 +391,21 @@ resets = <&rst WATCHDOG3_RESET>; status = "disabled"; }; + + qspi: spi at ff8d2000 { + compatible = "cdns,qspi-nor";
arch/arm/dts/socfpga_stratix10.dtsi line 406
Quoted 10 lines
arch/arm/dts/socfpga_stratix10.dtsi +10
-0+ #address-cells = <1>; + #size-cells = <0>; + reg = <0xff8d2000 0x100>, + <0xff900000 0x100000>; + interrupts = <0 3 4>; + cdns,fifo-depth = <128>; + cdns,fifo-width = <4>; + cdns,trigger-address = <0x00000000>; + bus-num = <0>; + /*spi-max-frequency = <50000000>;*/
Please ignore this patch. Just noticed add this unused /* */ line here. Will resend again.
Regards
Ley Foon
PATCH 1/1 arm: dts: Stratix10: Add QSPI node
Quoted 30 lines · Ley Foon Tan
Quoted 29 lines · Ley Foon Tan
Add QSPI device tree to Stratix 10. Sync from Linux Stratix 10 dts.
Tested on Stratix 10 SoC devkit.
SOCFPGA_STRATIX10# sf probe 0:0
SF: Detected mt25qu02g with page size 256 Bytes, erase size 64 KiB, total 256 MiBSigned-off-by Ley Foon Tan <[email protected]>--- arch/arm/dts/socfpga_stratix10.dtsi | 16 ++++++++++++++++ arch/arm/dts/socfpga_stratix10_socdk.dts | 21 +++++++++++++++++++++ 2 files changed, 37 insertions(+)arch/arm/dts/socfpga_stratix10.dtsi +7
-0@@ -391,5 +391,21 @@ resets = <&rst WATCHDOG3_RESET>; status = "disabled"; }; + + qspi: spi at ff8d2000 { + compatible = "cdns,qspi-nor"; + #address-cells = <1>; + #size-cells = <0>; + reg = <0xff8d2000 0x100>, + <0xff900000 0x100000>;
Quoted 8 lines
arch/arm/dts/socfpga_stratix10.dtsi line 406
Quoted 6 lines
arch/arm/dts/socfpga_stratix10.dtsi +6
-0+ interrupts = <0 3 4>; + cdns,fifo-depth = <128>; + cdns,fifo-width = <4>; + cdns,trigger-address = <0x00000000>; + bus-num = <0>; + /*spi-max-frequency = <50000000>;*/Please ignore this patch. Just noticed add this unused /* */ line here. Will resend again.
Then it'd be V2 .
Signature · 2 lines
Best regards, Marek Vasut
PATCH 1/1 arm: dts: Stratix10: Add QSPI node
In reply to Ley Foon TanQuoted 54 lines · Ley Foon Tan
Add QSPI device tree to Stratix 10. Sync from Linux Stratix 10 dts.
Tested on Stratix 10 SoC devkit.
SOCFPGA_STRATIX10# sf probe 0:0
SF: Detected mt25qu02g with page size 256 Bytes, erase size 64 KiB, total 256 MiBSigned-off-by Ley Foon Tan <[email protected]>--- arch/arm/dts/socfpga_stratix10.dtsi | 16 ++++++++++++++++ arch/arm/dts/socfpga_stratix10_socdk.dts | 21 +++++++++++++++++++++ 2 files changed, 37 insertions(+)arch/arm/dts/socfpga_stratix10.dtsi +16
-0@@ -391,5 +391,21 @@ resets = <&rst WATCHDOG3_RESET>; status = "disabled"; }; + + qspi: spi at ff8d2000 { + compatible = "cdns,qspi-nor"; + #address-cells = <1>; + #size-cells = <0>; + reg = <0xff8d2000 0x100>, + <0xff900000 0x100000>; + interrupts = <0 3 4>; + cdns,fifo-depth = <128>; + cdns,fifo-width = <4>; + cdns,trigger-address = <0x00000000>; + bus-num = <0>; + /*spi-max-frequency = <50000000>;*/ + status = "disabled"; + u-boot,dm-pre-reloc; + }; }; };arch/arm/dts/socfpga_stratix10_socdk.dts +1
-0@@ -10,6 +10,7 @@ aliases { serial0 = &uart0; + spi0 = &qspi; }; chosen {@@ -87,6 +88,26 @@ smplsel = <0>;
arch/arm/dts/socfpga_stratix10_socdk.dts line 98
Quoted 10 lines
arch/arm/dts/socfpga_stratix10_socdk.dts +8
-0}; +&qspi { + status = "okay"; + + flash at 0 { + u-boot,dm-pre-reloc; + #address-cells = <1>; + #size-cells = <1>; + compatible = "spi-flash";
"spi-flash" is u-boot specific and about to be deprecated. You should use the linux-compatible "jedec,spi-nor" binding.
Regards,
Simon
Quoted 17 lines
arch/arm/dts/socfpga_stratix10_socdk.dts +12
-1+ reg = <0>; /* chip select */ + spi-max-frequency = <50000000>; + + page-size = <256>; + block-size = <16>; /* 2^16, 64KB */ + cdns,tshsl-ns = <50>; + cdns,tsd2d-ns = <50>; + cdns,tchsh-ns = <4>; + cdns,tslch-ns = <4>; + }; +}; + &uart0 { status = "okay"; }; --2.19.0
PATCH 1/1 arm: dts: Stratix10: Add QSPI node
Quoted 58 lines · Simon Goldschmidt
Quoted 56 lines · Ley Foon Tan
Add QSPI device tree to Stratix 10. Sync from Linux Stratix 10 dts.
Tested on Stratix 10 SoC devkit.
SOCFPGA_STRATIX10# sf probe 0:0
SF: Detected mt25qu02g with page size 256 Bytes, erase size 64 KiB, total 256 MiBSigned-off-by Ley Foon Tan <[email protected]>--- arch/arm/dts/socfpga_stratix10.dtsi | 16 ++++++++++++++++ arch/arm/dts/socfpga_stratix10_socdk.dts | 21 +++++++++++++++++++++ 2 files changed, 37 insertions(+)arch/arm/dts/socfpga_stratix10.dtsi +16
-0@@ -391,5 +391,21 @@ resets = <&rst WATCHDOG3_RESET>; status = "disabled"; }; + + qspi: spi at ff8d2000 { + compatible = "cdns,qspi-nor"; + #address-cells = <1>; + #size-cells = <0>; + reg = <0xff8d2000 0x100>, + <0xff900000 0x100000>; + interrupts = <0 3 4>; + cdns,fifo-depth = <128>; + cdns,fifo-width = <4>; + cdns,trigger-address = <0x00000000>; + bus-num = <0>; + /*spi-max-frequency = <50000000>;*/ + status = "disabled"; + u-boot,dm-pre-reloc; + }; }; };arch/arm/dts/socfpga_stratix10_socdk.dts +1
-0@@ -10,6 +10,7 @@ aliases { serial0 = &uart0; + spi0 = &qspi; }; chosen {@@ -87,6 +88,26 @@ smplsel = <0>; };
Quoted 11 lines
arch/arm/dts/socfpga_stratix10_socdk.dts line 98
Quoted 8 lines
arch/arm/dts/socfpga_stratix10_socdk.dts +8
-0+&qspi { + status = "okay"; + + flash at 0 { + u-boot,dm-pre-reloc; + #address-cells = <1>; + #size-cells = <1>; + compatible = "spi-flash";"spi-flash" is u-boot specific and about to be deprecated. You should use the linux-compatible "jedec,spi-nor" binding.
Okay, will change in next revision.
Regards
Ley Foon