can: sja1000: f81601: add Fintek F81601 support
Subsystems (3)
PATCH v3 1/1 can: sja1000: f81601: add Fintek F81601 support
This patch add support for Fintek PCIE to 2 CAN controller support
Signed-off-by Ji-Ze Hong (Peter Hong) <[email protected]>
---
v3:
1: Fix module parameter "internal_clk" default from 1 to true. 2: Remove non-usable pcim_iounmap().
v2:
1: Fix comment on the spinlock with write access. 2: Use ARRAY_SIZE instead of F81601_PCI_MAX_CHAN. 3: Check the strap pin outside the loop.
4: Fix the cleanup issue in f81601_pci_add_card(). 5: Remove unused "channels" in struct f81601_pci_card.
drivers/net/can/sja1000/Kconfig | 8 ++ drivers/net/can/sja1000/Makefile | 1 + drivers/net/can/sja1000/f81601.c | 213 +++++++++++++++++++++++++++++++++++++++ 3 files changed, 222 insertions(+) create mode 100644 drivers/net/can/sja1000/f81601.c
drivers/net/can/sja1000/Kconfig +8 -0
@@ -101,4 +101,12 @@ config CAN_TSCAN1 IRQ numbers are read from jumpers JP4 and JP5, SJA1000 IO base addresses are chosen heuristically (first that works). +config CAN_F81601 + tristate "Fintek F81601 PCIE to 2 CAN Controller" + depends on PCI + help + This driver adds support for Fintek F81601 PCIE to 2 CAN Controller. + It had internal 24MHz clock source, but it can be changed by + manufacturer. We can use modinfo to get usage for parameters. + Visit http://www.fintek.com.tw to get more information. endif
drivers/net/can/sja1000/Makefile +1 -0
@@ -13,3 +13,4 @@ obj-$(CONFIG_CAN_PEAK_PCMCIA) += peak_pcmcia.o obj-$(CONFIG_CAN_PEAK_PCI) += peak_pci.o obj-$(CONFIG_CAN_PLX_PCI) += plx_pci.o obj-$(CONFIG_CAN_TSCAN1) += tscan1.o +obj-$(CONFIG_CAN_F81601) += f81601.o
drivers/net/can/sja1000/f81601.c new file +213 -0
213 lines not on this page · raw message
Signature · 1 line
2.7.4