Skip to contentSkip to conversation

verifying set-mark

DISCUSSION Casey Scott 2 participants 3 messages Feb 24, 2008 1 message not in the archive

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive
Quoted 9 lines

Now, I don't seem to have a man page for tc-filters, I can't find it on the internet, nor can I find it in the source (I looked in iproute2-2.6.19-061214), so I'm afraid nobody's got it which makes this a dead end.

There surely must be examples around that show how to work with tc and iptables' mark. Perhaps this will get you going:
http://www.szabilinux.hu/bandwidth/index.html

Thanks for that link. I realized that I was marking on POSTROUTING rather than FORWARD. The correction solved the problem of throttling, however, I'd still like to know how to use tcpdump to verify the mark is being set.

Thanks,
Casey

Quoted 6 lines

Grts,
Rob

#2 lore raw
Quoted 3 lines · Casey Scott

Thanks for that link. I realized that I was marking on POSTROUTING rather than FORWARD. The correction solved the problem of throttling, however, I'd still like to know how to use tcpdump to verify the mark is being set.

You cannot. The mark is a kernel internal thingy. Tcpdump sees the packets "on the wire", the mask is long gone by that time.

HTH,
M4

#3 lore raw
Quoted 8 lines
Quoted 6 lines

Thanks for that link. I realized that I was marking on POSTROUTING rather than FORWARD. The correction solved the problem of throttling, however, I'd still like to know how to use tcpdump to

verify the mark is being set.

Quoted 5 lines

You cannot. The mark is a kernel internal thingy. Tcpdump sees the packets "on the wire", the mask is long gone by that time.

HTH,
M4

That explains a lot! Thanks.

Casey