ARM: dts: aspeed: rainier: Add directly controlled LEDs
Subsystems (2)
PATCH v2 2/2 ARM: dts: aspeed: rainier: Add directly controlled LEDs
From: Vishwanatha Subbanna <[email protected]>
These are the LEDs that have direct GPIO connection from ASPEED
Signed-off-by Vishwanatha Subbanna <[email protected]>
Reviewed-by Eddie James <[email protected]>
--- arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 24 ++++++++++++++++++++++-- 1 file changed, 22 insertions(+), 2 deletions(-)
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts +22 -2
@@ -124,6 +124,26 @@ leds { compatible = "gpio-leds"; + /* BMC Card fault LED at the back */ + bmc-ingraham0 { + gpios = <&gpio0 ASPEED_GPIO(H, 1) GPIO_ACTIVE_LOW>; + }; + + /* Enclosure ID LED at the back */ + rear-enc-id0 { + gpios = <&gpio0 ASPEED_GPIO(H, 2) GPIO_ACTIVE_LOW>; + }; + + /* Enclosure fault LED at the back */ + rear-enc-fault0 { + gpios = <&gpio0 ASPEED_GPIO(H, 3) GPIO_ACTIVE_LOW>; + }; + + /* PCIE slot power LED */ + pcieslot-power { + gpios = <&gpio0 ASPEED_GPIO(P, 4) GPIO_ACTIVE_LOW>; + }; + /* System ID LED that is at front on Op Panel */ front-sys-id0 { retain-state-shutdown;
@@ -167,7 +187,7 @@ /*E0-E7*/ "","","","","","","","", /*F0-F7*/ "","","","","","","","", /*G0-G7*/ "","","","","","","","", - /*H0-H7*/ "","","","","","","","", + /*H0-H7*/ "","bmc-ingraham0","rear-enc-id0","rear-enc-fault0","","","","", /*I0-I7*/ "","","","","","","","", /*J0-J7*/ "","","","","","","","", /*K0-K7*/ "","","","","","","","",
@@ -175,7 +195,7 @@ /*M0-M7*/ "","","","","","","","", /*N0-N7*/ "","","","","","","","", /*O0-O7*/ "","","","usb-power","","","","", - /*P0-P7*/ "","","","","","","","", + /*P0-P7*/ "","","","","pcieslot-power","","","", /*Q0-Q7*/ "cfam-reset","","","","","","","", /*R0-R7*/ "","","","","","","","", /*S0-S7*/ "presence-ps0","presence-ps1","presence-ps2","presence-ps3",
Signature · 1 line
1.8.3.1