Skip to contentSkip to conversation

MPC8260 Interrupt Request

DISCUSSION [email protected] 2 participants 2 messages Oct 25, 2001 – Oct 26, 2001

lore
Share & tools
lore
#0 lore raw

I've connected a SanDisk compact flash to the 8260 local bus and have the interrupt pin wired to ~IRQ1 of the 8260. When I call function 'request_8xxirq' what interrupt number should I be requesting?

The 8260 User's manual says that IRQ1 is interrupt number 19, but if I request that interrupt number it does not work.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#1 lore raw
Quoted 1 line · [email protected] wrote:

The 8260 User's manual says that IRQ1 is interrupt number 19,

That's the correct number to use. Have you configured the rest of the interrupt controller properly? You need to at least configure SIEXR for level/edge and SIUMCR to enable the IRQ1 pin. Of course, this means you can't enable external snooping due to pin multiplexing, so I hope that's OK in your system design.

	-- Dan

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/