[2.6.9] unhandled OHCI IRQs...
When plugging in an Epson C62 USB 1.1 printer to my nForce 2 OHCI + EHCI USB controllers, the IRQ doesn't seem to get handled [1]. Tried both with acpi=noirq and without, printer support and full USB support enabled. Kernel is 2.6.9.
Any ideas?
--- [1]
irq 7: nobody cared!
[<c01063d4>] __report_bad_irq+0x24/0x80 [<c01064b1>] note_interrupt+0x61/0x90 [<c010637b>] handle_IRQ_event+0x2b/0x60 [<c010676a>] do_IRQ+0x11a/0x130 [<c010479c>] common_interrupt+0x18/0x20 [<c0119f30>] __do_softirq+0x30/0x90 [<c0119fb6>] do_softirq+0x26/0x30 [<c010674b>] do_IRQ+0xfb/0x130 [<c010479c>] common_interrupt+0x18/0x20 [<c0101df0>] default_idle+0x0/0x30 [<c0101e13>] default_idle+0x23/0x30 [<c0101e8a>] cpu_idle+0x3a/0x60 [<c035c8e1>] start_kernel+0x141/0x160 [<c035c530>] unknown_bootoption+0x0/0x160
handlers:
[<c022dcd0>] (usb_hcd_irq+0x0/0x60)
Disabling IRQ #7
spurious 8259A interrupt: IRQ7.
--- [2]
# grep hcd /proc/interrupts 5: 0 XT-PIC ohci_hcd 7: 164004 XT-PIC ohci_hcd 12: 2 XT-PIC ehci_hcd
Signature · 4 lines
Daniel J Blueman +++ GMX DSL Premiumtarife 3 Monate gratis* + WLAN-Router 0,- EUR* +++ Clevere DSL-Nutzer wechseln jetzt zu GMX: http://www.gmx.net/de/go/dsl
Quoted 6 lines · Daniel Blueman
When plugging in an Epson C62 USB 1.1 printer to my nForce 2 OHCI + EHCI USB controllers, the IRQ doesn't seem to get handled [1]. Tried both with acpi=noirq and without, printer support and full USB support enabled. Kernel is 2.6.9.
Any ideas?
Make sure your BIOS isn't trying to do any more with USB than just enabling the hardware ... or try the new PCI "quirk" flag affecting boot-time handling of USB, merged in 2.6.10-rc1.
- Dave