Skip to contentSkip to conversation

About the fix "e1000e: workaround for packet drop on 82579 at 100Mbps (commit 0ed013e28fe853244f4972cf18d8e2bd62eeb8fc)"

DISCUSSION Artem S. Tashkinov 2 participants 2 messages Nov 2, 2011 – Nov 4, 2011

lore
Share & tools
lore
#0 lore raw

Hello,

I'm now running Linux 3.0.8 and I still see this issue:

$ ifconfig eth0

eth0 Link encap:Ethernet HWaddr f4:6d:04:39:XX:XX

          inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:123911 errors:0 dropped:386 overruns:0 frame:0
          TX packets:122441 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:96626066 (92.1 MiB)  TX bytes:15191495 (14.4 MiB)
          Interrupt:18 Memory:fb500000-fb520000

More about this particular onboard NIC (motherboard ASUS P8P67 PRO Rev 3.0)

# lspci -vvv -s 00:19.0

00:19.0 Ethernet controller: Intel Corporation 82579V Gigabit Network Connection (rev 05)
Subsystem: ASUSTeK Computer Inc. Device 849c
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 49
Region 0: Memory at fb500000 (32-bit, non-prefetchable) [size=128K]
Region 1: Memory at fb528000 (32-bit, non-prefetchable) [size=4K]
Region 2: I/O ports at f040 [size=32]
Capabilities: [c8] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [d0] MSI: Enable+ Count=1/1 Maskable- 64bit+
Address: 00000000fee0100c Data: 416a
Capabilities: [e0] PCI Advanced Features
AFCap: TP+ FLR+
AFCtrl: FLR-
AFStatus: TP-
Kernel driver in use: e1000e
Kernel modules: e1000e

# ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: No
        Advertised auto-negotiation: Yes
        Speed: 100Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 2
        Transceiver: internal
        Auto-negotiation: on
        MDI-X: off
        Supports Wake-on: pumbg
        Wake-on: d
        Current message level: 0x00000001 (1)
                               drv
        Link detected: yes

I'm not absolutely certain about the quality of equipment I'm connected to - so I'd like to know how can I remove it out of equation.

My Internet connection seemingly works this way:

My_PC -> 16-port unmanageable Ethernet switch -> Cisco Ethernet switch -> Cisco PPPoE concentrator (the first device I can ping via PPPoE connection)

Best wishes,

Artem

#1 lore raw
Quoted 83 lines

-----Original Message-----
From: Artem S. Tashkinov [mailto:[email protected]]
Sent: Wednesday, November 02, 2011 5:09 AM
To: Allan, Bruce W; Kirsher, Jeffrey T
Cc: [email protected]
Subject: About the fix "e1000e: workaround for packet drop on 82579 at 100Mbps (commit 0ed013e28fe853244f4972cf18d8e2bd62eeb8fc)"

Hello,

I'm now running Linux 3.0.8 and I still see this issue:

$ ifconfig eth0

eth0 Link encap:Ethernet HWaddr f4:6d:04:39:XX:XX

         inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
         RX packets:123911 errors:0 dropped:386 overruns:0 frame:0
         TX packets:122441 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:1000
         RX bytes:96626066 (92.1 MiB)  TX bytes:15191495 (14.4 MiB)
         Interrupt:18 Memory:fb500000-fb520000

More about this particular onboard NIC (motherboard ASUS P8P67 PRO Rev 3.0)

# lspci -vvv -s 00:19.0

00:19.0 Ethernet controller: Intel Corporation 82579V Gigabit Network Connection (rev 05)
Subsystem: ASUSTeK Computer Inc. Device 849c
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-

       Latency: 0
       Interrupt: pin A routed to IRQ 49
       Region 0: Memory at fb500000 (32-bit, non-prefetchable) [size=128K]
       Region 1: Memory at fb528000 (32-bit, non-prefetchable) [size=4K]
       Region 2: I/O ports at f040 [size=32]
       Capabilities: [c8] Power Management version 2
               Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-

,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [d0] MSI: Enable+ Count=1/1 Maskable- 64bit+
Address: 00000000fee0100c Data: 416a
Capabilities: [e0] PCI Advanced Features
AFCap: TP+ FLR+
AFCtrl: FLR-
AFStatus: TP-
Kernel driver in use: e1000e
Kernel modules: e1000e

# ethtool eth0
Settings for eth0:
       Supported ports: [ TP ]
       Supported link modes:   10baseT/Half 10baseT/Full
                               100baseT/Half 100baseT/Full
                               1000baseT/Full
       Supports auto-negotiation: Yes
       Advertised link modes:  10baseT/Half 10baseT/Full
                               100baseT/Half 100baseT/Full
                               1000baseT/Full
       Advertised pause frame use: No
       Advertised auto-negotiation: Yes
       Speed: 100Mb/s
       Duplex: Full
       Port: Twisted Pair
       PHYAD: 2
       Transceiver: internal
       Auto-negotiation: on
       MDI-X: off
       Supports Wake-on: pumbg
       Wake-on: d
       Current message level: 0x00000001 (1)
                              drv
       Link detected: yes

I'm not absolutely certain about the quality of equipment I'm connected to - so I'd like to know how can I
remove it out of equation.

My Internet connection seemingly works this way:

Quoted 7 lines

My_PC -> 16-port unmanageable Ethernet switch -> Cisco Ethernet switch -> Cisco PPPoE concentrator (the
first device I can ping via PPPoE connection)

Best wishes,

Artem

Your issue might not be the same as the one fixed by the subject patch. Please file a bug at http://e1000.sf.net with the information you have provided in this email as well as a description of the type of traffic is going on when you see the packet drops happen.

Thanks,
Bruce. ���{.n�+�������+%�����ݶ��w��{.n�+����{��G�����{ay�ʇڙ�,j��f���h��������z_�(�階�ݢj"���m������G������?����&���~��iO��z��v�^�m���� ������?�I�