patch "serial: tegra: Only print FIFO error message when an error occurs" added to tty-linus

This is a note to let you know that I've just added the patch titled

serial: tegra: Only print FIFO error message when an error occurs

to my tty git tree which can be found at
git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty.git
in the tty-linus branch.

The patch will show up in the next release of the linux-next tree (usually sometime within the next 24 hours during the week.)

The patch will hopefully also be merged in Linus's tree for the next -rc kernel release.

If you have any questions about this process, please let me know.

From cc9ca4d95846cbbece48d9cd385550f8fba6a3c1 Mon Sep 17 00:00:00 2001
From: Jon Hunter <[email protected]>
Date: Wed, 30 Jun 2021 13:56:43 +0100
Subject: serial: tegra: Only print FIFO error message when an error occurs

The Tegra serial driver always prints an error message when enabling the FIFO for devices that have support for checking the FIFO enable status. Fix this by displaying the error message, only when an error occurs.

Finally, update the error message to make it clear that enabling the FIFO failed and display the error code.

---
 drivers/tty/serial/serial-tegra.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

index 222032792d6c..eba5b9ecba34 100644
@@ -1045,9 +1045,11 @@ static int tegra_uart_hw_init(struct tegra_uart_port *tup)
 
 	if (tup->cdata->fifo_mode_enable_status) {
 		ret = tegra_uart_wait_fifo_mode_enabled(tup);
-		dev_err(tup->uport.dev, "FIFO mode not enabled\n");
-		if (ret < 0)
+		if (ret < 0) {
+			dev_err(tup->uport.dev,
+				"Failed to enable FIFO mode: %d\n", ret);
 			return ret;
+		}
 	} else {
 		/*
 		 * For all tegra devices (up to t210), there is a hardware

2.32.0