kernel-2.6.25-rc2, CPU C state "active state" always remain C0 unchangeable by cat 'proc/'
On Fedora9 Alpha with kernel-2.6.25-rc2,
I run " watch -n 0.1 "cat /proc/acpi/processor/CPU*/power | grep 'active state'" ", I find that the CPU C state information "active state" remain at "C0" and it do not change any time. The same issue also exit on 2.6.24-rc2 kernel.
But with RHEL5.1 kernel-2.6.18 the CPU C state information is normal.
Every 0.1s: cat /proc/acpi/processor/CPU*/power | grep 'active state'
Thu Feb 21 09:44:33 2008
active state: C0 active state: C0 active state: C0 active state: C0 active state: C0 active state: C0 active state: C0 active state: C0
On RHEL5.1 kernel-2.6.18-53.el5
[root@localhost ~]# cat /proc/acpi/processor/CPU*/power | grep 'active state'
active state: C2 active state: C2 active state: C2 active state: C2 active state: C2 active state: C3 active state: C2 active state: C3
The hardware platform: bensley and santarosa.
Quoted 48 lines
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of [email protected]
Sent: Wednesday, February 20, 2008 11:01 PM
To: [email protected]
Cc: Song, Youquan
Subject: kernel-2.6.25-rc2, CPU C state "active state" always remain C0 unchangeable by cat 'proc/'On Fedora9 Alpha with kernel-2.6.25-rc2,
I run " watch -n 0.1 "cat/proc/acpi/processor/CPU*/power| grep 'active
state'" ", I find that the CPU C state information "active state" remain
at "C0" and it do not change any time. The same issue also exit on 2.6.24-rc2 kernel.
But with RHEL5.1 kernel-2.6.18 the CPU C state information is normal.Every 0.1s: cat
/proc/acpi/processor/CPU*/power| grep 'active state'Thu Feb 21 09:44:33 2008
active state: C0 active state: C0 active state: C0 active state: C0 active state: C0 active state: C0 active state: C0 active state: C0On RHEL5.1 kernel-2.6.18-53.el5
[root@localhost ~]# cat/proc/acpi/processor/CPU*/power| grep 'active state'active state: C2 active state: C2 active state: C2 active state: C2 active state: C2 active state: C3 active state: C2 active state: C3
Quoted 2 lines
The hardware platform: bensley and santarosa.
I am not sure active state gives a lot of information about C-state. And I really hate to see code waking up every .1 sec to check the active state :-)./proc/acpi/processor/*/power is marked deprecated upstream and if you really want this field, you will have to disable CONFIG_CPU_IDLE in upstream kernel. With CPU_IDLE you will get more detailed information about all C-states entry counts and residencies under /sys/devices/system/cpu/cpu*/cpuidle/
Thanks,
Venki