Skip to contentSkip to conversation

FAILED: patch "[PATCH] xhci: Keep interrupt disabled in initialization until host is" failed to apply to 4.14-stable tree

PATCH [email protected] 1 participant 1 message Jun 27, 2022

Subsystems (3)
Stable branch USB USB xHCI driver
lore
Share & tools
lore

[email protected]

author maintainer
#0 lore raw

The patch below does not apply to the 4.14-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From a808925075fb750804a60ff0710614466c396db4 Mon Sep 17 00:00:00 2001
From: Hongyu Xie <[email protected]>
Date: Thu, 23 Jun 2022 14:19:42 +0300
Subject: [PATCH] xhci: Keep interrupt disabled in initialization until host is
running.

irq is disabled in xhci_quiesce(called by xhci_halt, with bit:2 cleared in USBCMD register), but xhci_run(called by usb_add_hcd) re-enable it. It's possible that you will receive thousands of interrupt requests after initialization for 2.0 roothub. And you will get a lot of warning like, "xHCI dying, ignoring interrupt. Shouldn't IRQs be disabled?". This amount of interrupt requests will cause the entire system to freeze.
This problem was first found on a device with ASM2142 host controller on it.

[tidy up old code while moving it, reword header -Mathias]

Cc [email protected]
Signed-off-by Hongyu Xie <[email protected]>
Signed-off-by Mathias Nyman <[email protected]>
Link https://lore.kernel.org/r/[email protected] open here
Signed-off-by Greg Kroah-Hartman <[email protected]>
drivers/usb/host/xhci.c +22 -13
index 9ac56e9ffc64..cb99bed5f755 100644
@@ -611,15 +611,37 @@ static int xhci_init(struct usb_hcd *hcd)
 
 static int xhci_run_finished(struct xhci_hcd *xhci)
 {
+	unsigned long	flags;
+	u32		temp;
+
+	/*
+	 * Enable interrupts before starting the host (xhci 4.2 and 5.5.2).
+	 * Protect the short window before host is running with a lock
+	 */
+	spin_lock_irqsave(&xhci->lock, flags);
+
+	xhci_dbg_trace(xhci, trace_xhci_dbg_init, "Enable interrupts");
+	temp = readl(&xhci->op_regs->command);
+	temp |= (CMD_EIE);
+	writel(temp, &xhci->op_regs->command);
+
+	xhci_dbg_trace(xhci, trace_xhci_dbg_init, "Enable primary interrupter");
+	temp = readl(&xhci->ir_set->irq_pending);
+	writel(ER_IRQ_ENABLE(temp), &xhci->ir_set->irq_pending);
+
 	if (xhci_start(xhci)) {
 		xhci_halt(xhci);
+		spin_unlock_irqrestore(&xhci->lock, flags);
 		return -ENODEV;
 	}
+
 	xhci->cmd_ring_state = CMD_RING_STATE_RUNNING;
 
 	if (xhci->quirks & XHCI_NEC_HOST)
 		xhci_ring_cmd_db(xhci);
 
+	spin_unlock_irqrestore(&xhci->lock, flags);
+
 	return 0;
 }
 

@@ -668,19 +690,6 @@ int xhci_run(struct usb_hcd *hcd)
 	temp |= (xhci->imod_interval / 250) & ER_IRQ_INTERVAL_MASK;
 	writel(temp, &xhci->ir_set->irq_control);
 
-	/* Set the HCD state before we enable the irqs */
-	temp = readl(&xhci->op_regs->command);
-	temp |= (CMD_EIE);
-	xhci_dbg_trace(xhci, trace_xhci_dbg_init,
-			"// Enable interrupts, cmd = 0x%x.", temp);
-	writel(temp, &xhci->op_regs->command);
-
-	temp = readl(&xhci->ir_set->irq_pending);
-	xhci_dbg_trace(xhci, trace_xhci_dbg_init,
-			"// Enabling event ring interrupter %p by writing 0x%x to irq_pending",
-			xhci->ir_set, (unsigned int) ER_IRQ_ENABLE(temp));
-	writel(ER_IRQ_ENABLE(temp), &xhci->ir_set->irq_pending);
-
 	if (xhci->quirks & XHCI_NEC_HOST) {
 		struct xhci_command *command;