FAILED: patch "[PATCH] can: mcp251xfd: mcp251xfd_register_get_dev_id(): use correct" failed to apply to 5.15-stable tree

The patch below does not apply to the 5.15-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From 0ff32bfa0e794ccc3601de7158b522bf736fa63c Mon Sep 17 00:00:00 2001
From: Marc Kleine-Budde <[email protected]>
Date: Thu, 16 Jun 2022 11:38:00 +0200
Subject: [PATCH] can: mcp251xfd: mcp251xfd_register_get_dev_id(): use correct
length to read dev_id

The device ID register is 32 bits wide. The driver uses incorrectly the size of a pointer to a u32 to calculate the length of the SPI transfer. This results in a read of 2 registers on 64 bit platforms. This is no problem on the Linux side, as the RX buffer of the SPI transfer is large enough. In the mpc251xfd chip this results in the read of an undocumented register. So far no problems were observed.

Fix the length of the SPI transfer to read the device ID register only.

index 34b160024ce3..3160881e89d9 100644
@@ -1778,7 +1778,7 @@ mcp251xfd_register_get_dev_id(const struct mcp251xfd_priv *priv, u32 *dev_id,
 	xfer[0].len = sizeof(buf_tx->cmd);
 	xfer[0].speed_hz = priv->spi_max_speed_hz_slow;
 	xfer[1].rx_buf = buf_rx->data;
-	xfer[1].len = sizeof(dev_id);
+	xfer[1].len = sizeof(*dev_id);
 	xfer[1].speed_hz = priv->spi_max_speed_hz_fast;
 
 	mcp251xfd_spi_cmd_read_nocrc(&buf_tx->cmd, MCP251XFD_REG_DEVID);