Skip to contentSkip to conversation

FAILED: patch "[PATCH] mmc: sdhci-of-arasan: Fix SDHCI_RESET_ALL for CQHCI" failed to apply to 4.19-stable tree

PATCH [email protected] 1 participant 1 message Nov 14, 2022

Subsystems (4)
lore
Share & tools
lore

[email protected]

author maintainer
#0 lore raw

The patch below does not apply to the 4.19-stable tree.
If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to <[email protected]>.

Possible dependencies:

5d249ac37fc2 ("mmc: sdhci-of-arasan: Fix SDHCI_RESET_ALL for CQHCI")

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From 5d249ac37fc2396e8acc1adb0650cdacae5a990d Mon Sep 17 00:00:00 2001
From: Brian Norris <[email protected]>
Date: Wed, 26 Oct 2022 12:42:04 -0700
Subject: [PATCH] mmc: sdhci-of-arasan: Fix SDHCI_RESET_ALL for CQHCI

SDHCI_RESET_ALL resets will reset the hardware CQE state, but we aren't tracking that properly in software. When out of sync, we may trigger various timeouts.

It's not typical to perform resets while CQE is enabled, but one particular case I hit commonly enough: mmc_suspend() -> mmc_power_off(). Typically we will eventually deactivate CQE (cqhci_suspend() -> cqhci_deactivate()), but that's not guaranteed -- in particular, if we perform a partial (e.g., interrupted) system suspend.

The same bug was already found and fixed for two other drivers, in v5.7 and v5.9:

5cf583f1fb9c ("mmc: sdhci-msm: Deactivate CQE during SDHC reset") df57d73276b8 ("mmc: sdhci-pci: Fix SDHCI_RESET_ALL for CQHCI for Intel
GLK-based controllers")

The latter is especially prescient, saying "other drivers using CQHCI might benefit from a similar change, if they also have CQHCI reset by SDHCI_RESET_ALL."

So like these other patches, deactivate CQHCI when resetting the controller. Do this via the new sdhci_and_cqhci_reset() helper.

This patch depends on (and should not compile without) the patch entitled "mmc: cqhci: Provide helper for resetting both SDHCI and CQHCI".

drivers/mmc/host/sdhci-of-arasan.c +2 -1
index 3997cad1f793..cfb891430174 100644
@@ -25,6 +25,7 @@
 #include <linux/firmware/xlnx-zynqmp.h>
 
 #include "cqhci.h"
+#include "sdhci-cqhci.h"
 #include "sdhci-pltfm.h"
 
 #define SDHCI_ARASAN_VENDOR_REGISTER	0x78
@@ -366,7 +367,7 @@ static void sdhci_arasan_reset(struct sdhci_host *host, u8 mask)
 	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
 	struct sdhci_arasan_data *sdhci_arasan = sdhci_pltfm_priv(pltfm_host);
 
-	sdhci_reset(host, mask);
+	sdhci_and_cqhci_reset(host, mask);
 
 	if (sdhci_arasan->quirks & SDHCI_ARASAN_QUIRK_FORCE_CDTEST) {
 		ctrl = sdhci_readb(host, SDHCI_HOST_CONTROL);