SDE calculations broken
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 25 lines · Richard Purdie via lists.openembedded.org
I was worried about the failures I was seeing in reproducible builds. I therefore put more instrumentation about where SDE is calculated in builds. There are some situations we'd not expect to see a value of SDE so I tried to write logic that describes it. It is harder than you'd think as the value isn't valid in fetch, unpack,
prepare_recipe_sysrootor*_setscenetasks. I tried to make the warnings conditional uponBB_CURRENTTASKonly to find that gets set later that the SDE function is called. I did add some hacks to make it get set earlier but we'll come back to how early it runs.Once it has a value, the function writes it to the datastore, since re-reading it all the time is high overhead. This means that the value is cached and once set, doesn't change.
In testing on the autobuilder, I found this log extract:
NOTE: Running task 196 of 2214 (virtual:native:/home/pokybuild/yocto-worker/buildtools/build/meta/recipes-devtools/rsync/rsync_3.2.3.bb:do_patch)
[...]
WARNING: Cannot find/home/pokybuild/yocto-worker/buildtools/build/build/tmp/work/core2-64-poky-linux/rsync/3.2.3-r0/source-date-epoch/__source_date_epoch.txt.SOURCE_DATE_EPOCHwill default to 1302044400 [...]
NOTE: recipe rsync-native-3.2.3-r0: taskdo_patch: Startedburied in:
https://autobuilder.yoctoproject.org/typhoon/#/builders/20/builds/4430/steps/11/logs/stdio
Quoted 8 lines
What worries me there is that rsync-native is looking in core2-64-poky-linux, i.e. the target rsync. How could that happen?
My theory is that SDE is being called early in parsing before the BBCLASSEXTEND has modified PN and friends.
At this point I'm very worried as the whole situation looks error and race prone . It may explain some of the instabilities I've been seeing though.
The above isn't as bad as it seems. When parsing the datastore during the recipe run the main datastore is finalized before the variants are finalized, only the latter ends up being used.
This is the real problem:
https://autobuilder.yoctoproject.org/typhoon/#/builders/15/builds/4386/steps/11/logs/warnings
i.e. the SDE caching is switching between different WORKDIRs as the datastore is changed. I've sent a workaround for this but it needs further thought.
Cheers,
Richard