2.4.x IDE: Statis=0x58 - Drive not ready for command
I get lots of errors like these:
kernel: PDC202XX: Secondary channel reset.
kernel: hdh: drive not ready for command
kernel: ide3: reset: success
kernel: hdf: status error: status=0x58 { DriveReady SeekComplete DataRequest }
kernel: hdf: drive not ready for command
kernel: hdh: status error: status=0x58 { DriveReady SeekComplete DataRequest }
kernel: hdh: drive not ready for command
kernel: hdh: status timeout: status=0xd0 { Busy }
kernel: PDC202XX: Secondary channel reset.
kernel: hdh: drive not ready for command
kernel: ide3: reset: success
* Running virtually every kernel since 2.4.17-2.4-21-x.
* All harddrives UDMA100.
* Tried with DMA and unmask IRQ off.
* Tried with and without ACPI, APIC and APM.
* Happens to all harddrives.
* Cabling, power, hardware and drives thorowly checked and replaced for testing.
* Tested with one VIA KT266a motherboard and two Intel 440BX
* SMART values good.
* To all my testing I have not found any problems with the hardware.
* When to many of these IDE error occur the system freezes.
* Errors occur with the internal controller as well as the two Promise PDC20268 (U100 Tx2) controllers.
What should I do to fix this? I do not want to run Windows as I need LVM to manage the diskspace. Windows does however run very stable.
Any tips or ideas are welcome!
Regards,
Anders
--------
PGP public key: https://tnonline.net/secure/pgp_key.txt
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 30 lines · Anders Widman
Quoted 29 lines
I get lots of errors like these:
kernel: PDC202XX: Secondary channel reset.
kernel: hdh: drive not ready for command
kernel: ide3: reset: success
kernel: hdf: status error: status=0x58 { DriveReady SeekComplete DataRequest }
kernel: hdf: drive not ready for command
kernel: hdh: status error: status=0x58 { DriveReady SeekComplete DataRequest }
kernel: hdh: drive not ready for command
kernel: hdh: status timeout: status=0xd0 { Busy }
kernel: PDC202XX: Secondary channel reset.
kernel: hdh: drive not ready for command
kernel: ide3: reset: success* Running virtually every kernel since 2.4.17-2.4-21-x.
* All harddrives UDMA100.
* Tried with DMA and unmask IRQ off.
* Tried with and without ACPI, APIC and APM.
* Happens to all harddrives.
* Cabling, power, hardware and drives thorowly checked and replaced for testing.
* Tested with one VIA KT266a motherboard and two Intel 440BX
* SMART values good.
* To all my testing I have not found any problems with the hardware.
* When to many of these IDE error occur the system freezes.
* Errors occur with the internal controller as well as the two Promise PDC20268 (U100 Tx2) controllers.
Quoted 8 lines
Quoted 4 lines
What should I do to fix this? I do not want to run Windows as I need LVM to manage the diskspace. Windows does however run very stable.
Any tips or ideas are welcome!
On errors you posted there are hdf & hdh. Do not you use slave-only configurations? You must not use slave-only with Promise. Never.
Petr
Nope. I use 4 drives on both cards.
--------
PGP public key: https://tnonline.net/secure/pgp_key.txt