How to create a build for ARM Cortex-A8, S5PV210
Hi. I'm new to yocto. So I have followed a tutorial and now I have crewated my first yocto distro for i386.
Now I need to create a build for my device. It is a Samsung S5PV210 device, Cortex A8. Here there is a description
http://www.friendlyarm.net/products/mini210
Can someone suggest me how to setup the yocto build for this target?
Regards.
+39.347.4070897
www.labcsp.com[1]
www.denisgottardello.it[2]
GMT+1
Skype: mrdebug
--------
[1] http://www.labcsp.com
[2] http://www.denisgottardello.it
Quoted 11 lines · Denis
Hi. I'm new to yocto. So I have followed a tutorial and now I have crewated my first yocto distro for i386.
Now I need to create a build for my device. It is a Samsung S5PV210 device, Cortex A8.
Here there is a description
http://www.friendlyarm.net/products/mini210
Can someone suggest me how to setup the yocto build for this target?
Start by creating a machine config. That could initially be very minimal, for example, just:
require conf/machine/include/tune-cortexa8.inc
might be enough to build a toolchain and a minimal rootfs image with command line tools which will run on your board (if the board comes with a pre-built kernel then you may be able to use the pre-built kernel to run the OE rootfs - just for an initial test).
Next step would be to create a kernel recipe, so that you can create a complete kernel + rootfs with OE.
After that, add recipes for any components which are machine specific but are not part of the kernel (e.g. out of tree kernel driver modules, etc).