no config opt for k8temp in 3.6.11
When I do a grep for K8 in my .config file all I get is the following:
Quoted 1 line
grep -i k8
/usr/local/hugedisk/src/linux-3.6.11/.config
CONFIG_MK8=yCONFIG_X86_POWERNOW_K8=y
When I try your grep command I get:
Quoted 1 line
grep -E "^CONFIG_SENSORS" /usr/local/hugedisk/src/linux-3.6.11/.config|grep K
CONFIG_SENSORS_K10TEMP=m
I will try doing a make mrproper and see if anything changes.
Thanks for the reply.
--
Steven DuChene
-----Original Message-----
Quoted 36 lines
From: Borislav Petkov <[email protected]>
Sent: Jan 4, 2013 3:35 PM
To: "Steven A. DuChene" <[email protected]>
Cc: [email protected]
Subject: Re: no config opt for k8temp in 3.6.11Quoted 4 lines · Steven A. DuChene
I have a few systems with AMD processors. One is a AMD Phenom II based system which uses a k10temp kernel module to get the CPU temperature. Another system has an Athlon64 processor which apparently is supposed to use a k8temp module to do the same thing. I have built a 3.6.11
Quoted 8 lines
kernel for each system that otherwise runs OpenSuSE-11.X. On the Phenom system the k10temp module is gets built and performs as expected. However on the Atlnon system even though I see the
k8temp.csource file in thedrivers/hwmondirectory there does not seem to be a way in the kernel config files available from the 3.6.11 kernel sources to actually select that the k8temp module should be built. Is this some oversight in the makeup of the kernel config files or am I missing something obvious?That's strange, I can select all the AMD power drivers on 3.6.11:
$ grep -E "^CONFIG_SENSORS" .config CONFIG_SENSORS_K8TEMP=m CONFIG_SENSORS_K10TEMP=m CONFIG_SENSORS_FAM15H_POWER=mCan you do 'make mrproper' and try regenerating your config? But remember, mrproper will remove your .config so you might want to save that upfront in case you need it.
HTH.
Signature · 2 lines
Regards/Gruss, Boris.