Quiet down "SCSI parity error detected" messages on bootup

Hi,

This patch helps my system boot faster, esp when using a serial console, since it ratelimits the "SCSI parity error detected" messages on bootup. I've got a dual channel card attached to an old P1000 library with two DLT70000 tape drives installed. Works great, just takes forever to bootup when I have tons of message spewing out.

Now they look like this:

  [   66.245351] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   66.327105] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   66.408925] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   66.490753] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   67.061737] scsi 1:0:3:0: ABORT operation started
  [   71.556526] __ratelimit: 11248 callbacks suppressed
  [   71.614935] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   71.696665] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   71.778415] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   71.860242] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae
  [   71.942065] sym0: SCSI parity error detected: SCR2=1 DBC=11000028 SBCL=ae

and it's *much* nicer. But I'll bet this patch is space damaged when
I send it. I'll resend it if need be from home.

Thanks.

--- ../2.6.29/drivers/scsi/sym53c8xx_2/sym_hipd.c 2009-05-29

    13:09:50.000000000 -0400
+++ drivers/scsi/sym53c8xx_2/sym_hipd.c 2009-05-21 11:11:17.000000000
    -0400
@@ -2278,8 +2278,9 @@
        int phase       = cmd & 7;
        struct sym_ccb *cp      = sym_ccb_from_dsa(np, dsa);

- printf("%s: SCSI parity error detected: SCR1=%d DBC=%x

        SBCL=%x\n",

- sym_name(np), hsts, dbc, sbcl);
+ if (printk_ratelimit())
+ printf("%s: SCSI parity error detected: SCR2=%d DBC=%x SBCL=%x\n",
+ sym_name(np), hsts, dbc, sbcl);

/*
* Check that the chip is connected to the SCSI BUS.