Skip to contentSkip to conversation

LARTC Digest, Vol 4, Issue 9

LARTC Radu CUGUT 2 participants 2 messages Jun 3, 2005

lore
Share & tools
lore

Radu CUGUT

author
#0 lore raw
Quoted 8 lines · Daniel Lopes

Ping a client you surely know should be connected to the switch. ARP will take the part to find out the hardware address so the packet can be delivered. If the switch is on it should find a hardware address and ARP should put it in your ARP cache. It´s independet from ICMP blocks and similar. So after trying to ping you should have an entry in your ARP table which you can control with "arp" command.

It seems that I didn't make myself quite clear ...

I want to know if there is a way to find out if a switch is working ok or not.

If there is something like a small device, that I plug into the switch, ant then if that device "reports in" ok, then I know the switch is working.

Like on a router... if you want to know if a router is doing it's job, than you send an ICMP echo request to a host on the other side of the router.
ME ----> ROUTER -----> testing host

well, I want the same thing but on an inferior layer, on a switch. ME -----> SWITCH ----> testing device

I want to know if thare can be such thing as a "testing device".

I thought of an ethernet card, that i plug in the switch, power the card up, and then somehot arping the card, from witch I know the MAC. ... but i don't think it works just like that :(.

Hope I was specific enough this time ....

Thanks for the (possible) answers.

Best regards,
Radu.

Signature · 8 lines
Radu Cugut

mobile: +40 742 045686
web:    http://rcugut.has.it
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
#1 lore raw
Quoted 12 lines · Radu CUGUT
Quoted 8 lines · Daniel Lopes

Ping a client you surely know should be connected to the switch. ARP will take the part to find out the hardware address so the packet can be delivered. If the switch is on it should find a hardware address and ARP should put it in your ARP cache. It´s independet from ICMP blocks and similar. So after trying to ping you should have an entry in your ARP table which you can control with "arp" command.

Quoted 4 lines

It seems that I didn't make myself quite clear ...

I want to know if there is a way to find out if a switch is working ok or not.

It seems you can´t read. To ping someone you exactly know is connected to the switch is the easiest way to get an arp cache entry. If you don´t get an entry the switch is not working or the other one is blocking arp what shouldn´t happen because he wouldn´t be able to receive any packets. Just try what I said. Blocking protocols like ICMP doesn´t have an impact on the work of arp respectively ethernet. Exactly spoken no impact of getting the hardware address.
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc