Skip to contentSkip to conversation

ath10k tx99-like test mode?

DISCUSSION Simon Wunderlich 3 participants 3 messages Mar 16, 2015 Qualcomm Atheros ATH10K wireless driver

lore
Share & tools
lore
#1 lore raw
Quoted 5 lines · Simon Wunderlich

Hi,

is there a test mode for ath10k where one can set different legacy/MCS rates to test output power levels in a lab? We used tx99 on ath9k for that purpose, is there an equivalent feature in ath10k as well?

My firmware and driver changes have recently given the ability to set fixed rates for all types of traffic.

Only caveat so far as that mgt frames (beacons and such) cannot be set to HT or VHT rates.

Stock firmware should be able to set all but mgt rates (bcast, ucast, mcast) with a firmware update, but stock firmware does not support setting mgt rate from what I can tell.

Maybe not quite as good as what you can do with ath9k, but perhaps good enough?

Thanks,
Ben

Quoted 11 lines

Thanks!
Simon

_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k

Signature · 7 lines
Ben Greear <[email protected]>
Candela Technologies Inc  http://www.candelatech.com

_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
#2 lore raw
In reply to Simon Wunderlich
Quoted 3 lines · Simon Wunderlich

is there a test mode for ath10k where one can set different legacy/MCS rates to test output power levels in a lab? We used tx99 on ath9k for that purpose, is there an equivalent feature in ath10k as well?

Simon,

I've asked about this before since a 'testmode' was added to ath10k several months ago, but was pretty much shot down. However, there's a nifty tool called wperf (https://github.com/anyfi/wperf) that might accomplish what you're after. I've yet to try it, but it does seem promising since you'll hopefully be able to use UDP traffic to inject frames into the air, though I'm not sure how the firmware will react.

- Pushpal

_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k