Skip to contentSkip to conversation

MCP750 and CPX2000 System

DISCUSSION Jim Somerville 1 participant 1 message Dec 22, 1998

lore
Share & tools
lore
#0 lore raw

Hi All,

I just wanted to tell the community that I have successfully netbooted an MCP750, as part of a CPX2000 system. It's a rescue kernel, and I had to work around the fact that I did not have residual data. Thanks to Eric Valette, and transitive thanks to all the developers that he thanked... now I just have to figure out how to get a full blown installation happening to disk.

Problems so far:
It finds the NCR scsi controller chip, but ends up timing out on some scsi command. I don't know what the command is yet. With this problem, I can't get at the disk and the cdrom.

It finds two IDE controllers as expected. No problem here.

It finds the 21140 ethernet chip, and programs it for MII. I use ifconfig to configure it, however RX seems to work but not TX. Weird.

If anyone can provide help, I'm at [email protected]. Hopefully this is not related to not having residual data....

Cheers,

-Jim

[[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. To unsubscribe from linuxppc-dev, send ]] [[ the message 'unsubscribe' to [email protected] ]]