Some planning issues.
Quoted 9 lines
Boot Loader
-----------We need to figure out how to load a kerne image; I suspect borrowing from openbsd and mklinux will be great.
I have knowledge of how this works from my time at HP. It is mildly complicated compared to other platforms. As far as I know, the document describing the process isn't available outside of HP but the mklinux guys obviously had access to it.
I can get something going here if no one else volunteers.
Note that my machine is a C160 (64-bit PA8000 based). I think most of you have 700 series machines. I should be able to get one going that will work in w=0 (32-bit) mode so that it will also work with the 700 machines. But someone with a 700 will need to test it and possibly hack it.
Quoted 5 lines
All of this is going to be terrifically difficult without someone with prior HPPA experience. However, we do have OpenBSD and mklinux to model things after. And hopefully we'll have docs.
These are good sources, but I hope we can get "real" docs from HP. There is tons of information about the PDC, IODC, boot process, and I/O architecture that would be very useful -- and its a lot easier to read about than pick through code. I can give what I know/remember.
Regards, Jason Eckhardt.
Quoted 6 lines
These are good sources, but I hope we can get "real" docs from HP. There is tons of information about the PDC, IODC, boot process, and I/O architecture that would be very useful -- and its a lot easier to read about than pick through code. I can give what I know/remember.
It's looking and sounding very likely that we will have an official source of "real" documentation from HP......
If we can come up with perhaps an initial wish list, that may be a good approach to take. Perhaps those who have working knowledge of this documentation or those working internally could suggest titles and document numbers and we can then push to have cleared for public consumption.
Obviously, there will be some documentation that we will definitely require ahead of others, so prioritizing our requests will be important. We will also have to look into an efficient means of distributing these documents once we have them in our hands.
I'll likely know more by the end of the week.
- Chris
I dont know if this helps much, but hp has an online manual titled "PA-RISC 1.1 Architecture and Instruction Set Reference Manual" that describes how to use the bus and chip...
I have this downloaded if anyone needs it and cant find it readily.
At the current time, my department has 2 715/50's and 6 700-RX units, and we would like to run linux on them. I have pa-mklinux working on one of the 715/50 using the stuff provided by the opengroup's effort. It seems to run extremly well.
If there is any help I can give, i'm more than willing to try stuff out :)
----------------------******-------------------
Steve Ball
NMT EE Department System and Network Admistrator
C/S 3392
Socorro, NM 87801
[email protected] http://www.ee.nmt.edu/~hamster
Work: (505) 835-5330 (Digital Lab)
Shop: (505) 835-5923 (Solar Racing Shop)
Home: (505) 835-6325 (South 335)
New Mexico Tech Psycho Caver Extraordinaire (http://www.nmt.edu/~nmtcaver)
The secret of flying is simple: Throw yourself at the ground and miss.
----------------------******-------------------
Quoted 7 lines · Christopher Beard
Quoted 6 lines
These are good sources, but I hope we can get "real" docs from HP. There is tons of information about the PDC, IODC, boot process, and I/O architecture that would be very useful -- and its a lot easier to read about than pick through code. I can give what I know/remember.
Quoted 3 lines · Steve Ball
I dont know if this helps much, but hp has an online manual titled "PA-RISC 1.1 Architecture and Instruction Set Reference Manual" that describes how to use the bus and chip...
So people know, this document is available at:
http://www.hp.com/nsa/pa1.1/html/acd-1.html
(thanks to Zach Brown for that URL)
- Alex
Signature · 3 lines
Alex deVries <[email protected]> Red Hat Contrib Net maintainer Ottawa, Canada
Will a 9000/725 do ?
/ Lars Segerlund.
I got plenty of spare drives, and mkLinux running to bootstrap.
Efficient means, net or CD ? possible ?
/ Lars Segerlund.
Here's a good book:
PA-RISC 2.0 ARCHITECTURE
by Gerry Kane
ISBN 0-13-182734-0
Prentice Hall
http://www.prenhall.com
Rich
----------------------------------------------------------------------
To unsubscribe: send e-mail to [email protected] with `unsubscribe' as the subject.