Drivers *dropped* between releases? (sis5513.c)
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
Lionel Bouton, 2004-04-03 00:50:09 +0200 :
[...]
Quoted 6 lines
The driver uses 2 ways of finding SiS Ide chips :
- by northbridge PCI ids, which is what was always used historically (and so you had to manually add each known SiS northbridge to a table),
- by probing the controller directly (avoids depending on a lazy coder to add entries in a table to make your chip work).
Quoted 6 lines
When the last was added, some PCI ids were removed from the table (being superfluous).
The very fact that the
sis5513.coutputs something in your log means that it has found something to handle, so the detection routine (whichever it is) works.
Indeed. The logs do show the type and brand of both the hard disk
drive and the CD-ROM drive. It's just that, uh, well, the kernel doesn't want to do anything with them afterwards...
Quoted 3 lines
I think there's a common problem with SiS chips : interrupt handling. I believe it is the source of your problem. I may find time to hack on this.
Thanks already :-)
Quoted 3 lines
You could try to remove PCI cards and/or disable VGA IRQ in the bios. On one of my SiS-based systems for example adding a PCI card can make it unbootable.
Hm. There's only one PCI card (Radeon 7000), and I'm not sure I can
boot without it, as there's no on-board VGA controller. I'll try the BIOS hack though.
More relevant info (maybe): I got an old version of the Debian
installer, which uses an older kernel, and the process goes on normally (well, it halts later because the built-in NIC has a stupid MAC address, but that's another problem).
Thanks for the tips, I'll see how it goes.
Roland.
Signature · 4 lines
Roland Mas Food, shelter, source code. -- Cyclic Software
Roland Mas wrote the following on 04/03/2004 10:19 AM :
Quoted 8 lines
[...]
More relevant info (maybe): I got an old version of the Debian
installer, which uses an older kernel, and the process goes on normally (well, it halts later because the built-in NIC has a stupid MAC address, but that's another problem).
If you can find the time, please check that this old installer doesn't use the sis5513 driver or DMA transfers. If it does both, I'd be really interested by the exact kernel version used. If it doesn't, you'd probably found yourself a workaround by disabling dma at boot time.
Best regards,
Signature · 7 lines
Lionel Bouton - inet6 --------------------------------------------------------------------- o Siege social: 51, rue de Verdun - 92158 Suresnes / _ __ _ Acces Bureaux: 33 rue Benoit Malon - 92150 Suresnes / /\ /_ / /_ France \/ \/_ / /_/ Tel. +33 (0) 1 41 44 85 36 Inetsys S.A. Fax +33 (0) 1 46 97 20 10