2.4.26 agpgart on Tyan K8W 32bit not working?
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hi,
Quoted 4 lines · gb
I'm using the generic 2.4.26 kernel on a Tyan K8W (dual opteron) with 4GB of memory and an NV18GL [Quadro4 NVS] graphics card. The K8W BIOS version is 2.02 (1.02 also exhibits the same behavior).
Let me limit the output to the interesting part:
Quoted 10 lines
On a 64bit kernel, the following is returned:
[greg@testpig3 greg]$ lspci
04:01.0 PCI bridge: Advanced Micro Devices [AMD] AMD-8151 AGP Bridge (rev 13)
05:00.0 VGA compatible controller: nVidia Corporation NV18GL [Quadro4 NVS] (rev a2)
05:00.0 VGA compatible controller: nVidia Corporation NV18GL [Quadro4 NVS] (rev a2)
Quoted 7 lines
On a 32-bit kernel, the following is returned:
[greg@profit linux]$ lspci
03:0c.0 FireWire (IEEE 1394): Texas Instruments TSB43AB22/A IEEE-1394a-2000 Controller (PHY/Link) 05:00.0 VGA compatible controller: nVidia Corporation NV18GL [Quadro4 NVS] (rev a2)
The AMD-8151 AGP Bridge on bus #4 is missing on the 32-bit kernel.
Quoted 8 lines
[greg@profit linux]$ dmesg | grep -i agp Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory:
3932M
agpgart: no supported devices found. [drm:drm_init] *ERROR* Cannot initialize the agpgart module.
0: NVRM: AGPGART: unable to retrieve symbol table
Well, I have experienced problems with Red Hat EL 3.0 32 bit where the old kernel doesn't support the AMD bridge. But on my tests a 2.4.25 kernel did well. So the problem is located elsewhere.
Quoted 4 lines
I have tried booting with:
kernel /vmlinuz-2.4.26-bangalore4-01 ro root=/dev/hda2 hdc=ide-scsi apm=power-off agp_try_unsupported=1
The question is how your kernel is configuring the PCI devices because the problem is that the bridge is not listed in the output of lspci. Try the boot parameter "pci=noacpi" so that PCI is configured the "old" way without using probably buggy ACPI tables from the BIOS. Anyway, your problem really looks very strange to me, because usally the kernel that doesn't see the bridge on bus #4 won't even see the AGP card on bus #5.
Regards,
Rainer
Signature · 1 line
Rainer König, Diplom-Informatiker (FH), Augsburg, Germany