gdb needs an sbi extension
To implement hardware breakpoints and watchpoints on the riscv, the trigger in M mode is required. We need an sbi extension for debugging to set the trigger.
Please give suggestions and feedback.
Regards,
Xiang W
Debug Extension (EID #0x44424755 "DBG")
=======================================
Function: Set Tiggers(FID #0)
-----------------------------
```c
struct trigger {
unsigned long address;
unsigned long length;
unsigned long rwx_mask;
unsigned long privilege_mask;
unsigned long resource_id;
};
```rwx_mask:
bit 0: read
bit 1: write
bit 2: execute
privilege_mask?
bit 0: U-Mode
bit 1: S-Mode
bit 2: H-Mode
bit 3: M-Mode
resource_id: This is a resource identifier, non-0, 0 is used to indicate that the resource is free. This flag is used to associate which trigger is used, and is useful when clearing settings.
```c struct sbiret sbi_debug_set_triggers(unsigned long addr_lo, unsigned long addr_hi, unsigned long num); ```
addr_lo and addr_hi are used to access address ranges whose physical address width is greater than XLEN. The addr_lo and addr_hi point to the struct trigger array.
num represents the number of elements in the array.
Trigger is a scarce resource and should be used as the context of the program, set when resuming execution, and cleared when swapped out. In order to reduce the number of sbi calls, the breakpoint information is passed through an array here.
Function: Clear Tiggers(FID #1)
--------------------------------
```c struct sbiret sbi_debug_clear_triggers(unsigned long addr_lo, unsigned long addr_hi, unsigned long num); ```
addr_lo and addr_hi are used to access address ranges whose physical address width is greater than XLEN. The addr_lo and addr_hi point to the struct trigger array.
num represents the number of elements in the array.
This call will undo all trigger settings.